27-21-16
 ALL  ú ú 01 Page 510 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 747-400 MAINTENANCE MANUAL
 (6)  S 415-031Close all access doors and install all access panels.
 (7)  S 865-032Remove electrical power if it is not necessary (Ref/24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-21-16
 ALL  ú ú 01 Page 511 ú Jun 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 RUDDER POWER CONTROL MODULE - REMOVAL/INSTALLATION
__________________________________________________
 1.  General_______
 A.  There are four tasks in this procedure. The first two are the removal and the installation of the rudder power control module (which is referred to as the PCM). The second two are the removal and the installation for the filters of the PCM.
 B.  The upper rudder PCM contains two inlet filters and one transfer filter. The lower rudder PCM contains one inlet filter and one transfer filter.
 C.  The removal and the installation procedures are the same for upper and lower rudder PCM.
 D.  The removal and the installation procedures are the same for the inlet and the transfer filters.
 E.  The removal and the installation procedures of the PCM solenoid valve and the PCM electrohydraulic servo valve are in 22-21-04/201.
 TASK 27-21-17-002-001
 2.  Rudder Power Control Module Removal (Fig. 201)___________________________________
 A.  Special Tools and Equipment
 (1)
3ME65B81000-1 Rudder Clamp

 B.  
References

 (1)
06-09-06/201, Stabilizer and Elevator Access Doors and Panels

 (2)
06-09-07/201, Fin and Rudder Access Doors and Panels

 (3)
09-11-00/201, Towing

 (4)
24-22-00/201, Manual Control

 (5)
29-11-00/201, Main Hydraulic Supply System

 (6)
IPC 27-21-15, Fig. 2

 (7)
IPC 27-21-16, Fig. 2

 C.  
Access

 (1)  
Location Zone 315-316 Area Aft of Stabilizer Box 324 Vertical Fin, Rear Spar to Trailing Edge 325 Lower Rudder 326 Upper Rudder

 (2)  
Access Panel
 315A Access Door
 324DL, 324DR Inspection Access Panel
 324FL, 324FR Inspection Access Panel
 324UL, 324UR Inspection Access Panel

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-21-17
 ALL  ú ú 01 Page 201 ú Oct 10/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 D. Prepare for the Removal
 S 492-073
 WARNING:_______MAKE SURE THE NOSE WHEELS POINT FORWARD. IF THE NOSE WHEELS DO NOT POINT FORWARD, THE NOSE GEAR CAN QUICKLY TURN TO THE CENTER POSITION WHEN YOU REMOVE THE TOW PIN. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (1)  Install the TOW PIN at the steering metering valve for the nose landing gear (Ref 09-11-00/201).
 NOTE: The nose gear will turn during the rudder operation if you do
____
 not install the TOW PIN.

 S 862-003
 (2)  Supply the electrical power (Ref 24-22-00/201).
 S 862-077
 WARNING: MAKE SURE THAT PERSONS AND EQUIPMENT ARE CLEAR OF ALL CONTROL
_______ SURFACES BEFORE YOU SUPPLY HYDRAULIC POWER. THE AILERONS, RUDDERS, ELEVATORS, FLAPS, SPOILERS, LANDING GEAR, AND THRUST REVERSERS CAN MOVE QUICKLY WHEN YOU SUPPLY HYDRAULIC POWER. THIS CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 (3)  
Supply hydraulic power to the hydraulic systems No. 1 and 2
 (Ref 29-11-00/201).

 S 862-005

 (4)  
Set the upper and lower rudder to the center position.

 S 862-074

 (5)  
Set the rudder trim to zero.

 S 492-006

 (6)  
Install the rudder clamps between the upper and lower rudders, and the rudders and vertical fin.

 (7)  
Remove the hydraulic power (Ref 29-11-00/201).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 2(151)