F 『
E C F M E
E E
E 56-5B E
E E
F. Make sure that this(these) circuit breaker(s) is(are) closed:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU ENGINE/1 AND 2/IGN/SYS A 1JH A03
FOR 1000EM1 49VU ENGINE/1/FADEC A/AND EIU 1 2KS1 A04 49VU ENGINE/1/HP FUEL SOV 1KC1 A01 121VU ENGINE/ENG1/OIL/PRESS 2EN1 N40 121VU ENGINE/ENG1/OIL/QTY 1EN1 N39 121VU ENGINE/IGN/ENG1/SYS B 3JH1 P41 121VU ENGINE/IGN/ENG1/SYS A BAT 2JH1 P39 121VU ENGINE/ENG1/FADEC B/AND EIU 1 4KS1 R41
FOR 1000EM2 49VU ENGINE/2/FADEC A/AND EIU 2 2KS2 A05 49VU ENGINE/2/HP FUEL SOV 1KC2 A02 121VU ENGINE/ENG2/OIL/PRESS 2EN2 N42 121VU ENGINE/ENG2/OIL/QTY 1EN2 N41 121VU ENGINE/IGN/ENG2/SYS B 3JH2 P42 121VU ENGINE/IGN/ENG2/SYS A BAT 2JH2 P40 121VU ENGINE/ENG2/FADEC B 4KS2 Q40
Subtask 71-00-00-869-089
G. Continue to prepare for test.
CAUTION : MAKE SURE THAT THE HYDRAULIC RESERVOIR PRESSURE IS IN THE
_______ CORRECT OPERATION RANGE BEFORE YOU START THE ENGINE. THE HYDRAULIC FLUID IS NECESSARY TO LUBRICATE THE HYDRAULIC PUMPS THAT THE ENGINE OPERATES.
(1) Supply the aircraft pneumatic system from a HP ground power unit or the APU (Ref. TASK 36-12-00-860-001) or (Ref. TASK 36-12-00-860-002). Make sure that the pressure of the air supply is between 25 psi (1.7 bar) and 55 psi (3.8 bar).
(2) Make sure that the pressure of the Green reservoir for the engine 1 (Yellow reservoir for the engine 2) is correct.
(3) Make sure that the engine 1(2) pump is serviceable (on the HYD/FUEL panel 40VU, the OFF legend of the ENG 1(2) PUMP pushbutton switch must be off).
(4) Do the EIS start procedure (Ref. TASK 31-60-00-860-001).
F 『 EEFF : ALL E Page 52371-00-00
E E May 01/04 ERE
ECES E
F 『
E C F M E
E E
E 56-5B E
E E
4. Procedure
_________
Subtask 71-00-00-710-071
A. Do this test:
CAUTION : MAKE SURE THAT THE ENG/MASTER 1(2) CONTROL SWITCH (ON THE PANEL
_______ 115VU) IS SET TO OFF BEFORE YOU START THE FUEL PUMPS.
CAUTION : DO NOT OPERATE THE ENGINE IF THE FUEL INLET PRESSURE IS NOT
_______ POSITIVE (THE FUEL IS NECESSARY TO LUBRICATE THE ENGINE FUEL PUMP AND THE HMU AND THUS PREVENT DAMAGE).
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
1. Supply the engine with fuel.
R NOTE : If the fuel line or fuel equipment has been disconnected/removed
____ R dowstream of the LP valve before the FADEC test with engine motoring, R start the fuel pumps and open the LP valve.
A. On the HYD/FUEL panel 40VU: - The OFF legends of these pushbutton
- Push all the FUEL/PUMPS switches go off.
pushbutton switches.
B. Open the circuit breaker - On the upper ECAM display unit this
1KC1(2) to open the LP valve. message comes into view:
- ENG 1(2) LP VALVE OPEN
- The single chime operates.
- The MASTER CAUT light comes on.
NOTE : If there is an engine fire, the fire shut off valve has an
____ override function to close the pylon LP valve if it was open.
2. Make sure that the throttle control lever of the engine 1(2) is in the idle stop position (zero on the graduated sector).
3. On the ENG panel 115VU:
- Set the On the lower ECAM display unit: ENG/MODE/CRANK/NORM/IGN/START - The ENGINE page comes into view.
F 『 EEFF : ALL E Page 52471-00-00
E E Nov 01/04 E E ECES E
F 『
E C F M E
E E
E 56-5B E
E E
-------------------------------------------------------------------------------ACTION RESULT -------------------------------------------------------------------------------
selector switch to CRANK.
4. On the overhead CTL & IND panel 22VU:
- Push the ENG/MAN START/1(2) pushbutton switch.
5. Motor the engine as long as it is necessary (to do this obey the starter limits: 120 seconds).
6. Make sure that:
- The engine operates.
- The oil pressure indication is positive.
- Make sure that the available air pressure is between 25 psi (1.7 bar) and 55 psi (3.8 bar).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM 動力裝置 POWER PLANT 1(38)
