(a) Open and remove the flap (5) of the emergency exit (8).
 NOTE : the applicable SLIDE ARMED indicator light (6) comes on.
____
R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-71-00Page A503 1 1 May 01/05 1 1 1CES 1

 Proximity Switches (5WN1, 5WN2, 6WN1, 6WN2) - Emergency Exits.
 Figure 515/TASK 52-71-00-991-016

R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-71-00Page A504 1 1 May 01/05 1 1 1CES 1

 (b) On the emergency exit, with a hexagonal socket wrench, turn the head of the latch pin (7) a quarter turn counterclockwise to retract the latch pin (7).
 NOTE : the SLIDE ARMED indicator light (6) goes off.____
 Subtask 52-71-00-010-078
 C. Removal of the Lining Panel
RRRR  (1) Remove the lining panel: FOR 5WN1 241CW, (Ref. TASK 25-23-47-000-002). FOR 5WN2 242LW, (Ref. TASK 25-23-47-000-002). FOR 6WN1 241LW, (Ref. TASK 25-23-47-000-002). FOR 6WN2 242LW, (Ref. TASK 25-23-47-000-002).
 (2) Remove the insulation blanket.
 Subtask 52-71-00-865-065
 D. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU EIS/SLIDES/ARM AND WARN/FLT 121VU EIS/SLIDES/ARM AND WARN/GND 121VU EIS/SDAC1 AND 2/DOOR/DET/PAX  15WN 13WN 48WV  P11P10P05 

R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-71-00Page A505 1 1 May 01/05 1 1 1CES 1

 4. Procedure
_________
 Subtask 52-71-00-820-073

 A. Adjustment of the Proximity Switch
 (Ref. Fig. 515/TASK 52-71-00-991-016)

 WARNING : DO NOT OPEN THE EMERGENCY EXIT DURING THE ADJUSTMENT.
_______
 (1)
 Make sure that the clearance J1 between the target (2) and the bracket (1) of the proximity switch (9) is 41.2 +1.0 -1.0 mm (1.6220 +0.0393 -0.0393 in.)

 (2)
 If necessary, adjust the target position as follows:

 (a) Loosen the locknut (4) to release the serrated washer (3) and adjust the target (2) to get the correct clearance J1.
 (b) Tighten the locknut (4).
 Subtask 52-71-00-865-066

 B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 48WV, 13WN, 15WN
 Subtask 52-71-00-710-065
 C. Operational Test
 (1) Do an operational test of the warning system related to the emergency exits (Ref. TASK 52-73-00-710-002).
 5. Close-up
________
 Subtask 52-71-00-410-081

 A. Installation of the Lining Panel
 (1)
 Install the insulation blanket.

 (2)
 Install the lining panel:

R FOR 5WN1 241CW, (Ref. TASK 25-23-47-400-002). FOR 5WN2 242CW, (Ref. TASK 25-23-47-400-002).
R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-71-00Page A506 1 1 May 01/05 1 1 1CES 1 FOR 6WN1

 241LW, (Ref. TASK 25-23-47-400-002). R
 FOR 6WN2
 242LW, (Ref. TASK 25-23-47-400-002).
 Subtask 52-71-00-410-082
 B. Close Access
 (1) Arm the escape slide of the applicable emergency exit as follows. (Ref. Fig. 515/TASK 52-71-00-991-016)
 (a) With a hexagonal socket wrench, turn the head of the latch pin
 (7) a quarter turn clockwise to extend the latch pin (7). NOTE : The SLIDE ARMED indicator light (6) comes on.
____
 (b) Install and close the cover flap (5) on the emergency exit (8). NOTE : The SLIDE ARMED indicator light (6) goes off.
____
 (2)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (3)
 Close the pasenger/crew door 831 (Ref. TASK 52-10-00-410-001).

 (a) Remove the access platform(s).
 Subtask 52-71-00-862-065

 C. De-energize the ground service network
 (Ref. TASK 24-42-00-862-001).

R 1EFF : 001-049, 051-099, 101-149, 201-299, 1 52-71-00Page A507 1 1 May 01/05 1 1 1CES 1 **ON A/C 301-399,

 TASK 52-71-00-820-009-B
 Adjustment of the Proximity Switches (5WN1, 5WN2, 6WN1, 6WN2) of the Emergency Exits with the CHECKING TOOL-DOORS
 1. Reason for the Job
__________________
 There is an alternative method for this procedure. This task gives one of
 the methods. For the other method refer to the other task in this page
 block.
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM DOORS 艙門8(24)