(6)
Remove the four screws (10) and the washers (11).
(7)
Remove the wave guide (12) from its support. Remove the window (13) and the O-rings (14).
(8)
Remove the twenty screws (6), the washers (5) and the attachment plates (4).
(9)
Remove the electrical connectors (3) from their housings.
(10) Put blanking caps on the disconnected electrical connectors (1), (3) and (9).
(11) Remove the eight screws (22) and the washers (23). **ON A/C 151-199,
Subtask 34-41-37-020-052-C
A. Removal of the Mounting tray
(1)
Disconnect the electrical connector (9).
(2)
Loosen the four clamps (7).
(3)
Disconnect the ventilation lines (8).
(4)
Put blanking plugs on the disconnected line ends (8).
(5)
Cut and remove the lockwire from the screws (10).
(6)
Remove the four screws (10) and the washers (11).
(7)
Remove the wave guide (12) from its support. Remove the window (13) and the O-rings (14).
(8)
Remove the twenty screws (6), the washers (5) and the attachment plates (4).
(9)
Remove the electrical connectors (3) from their housings.
(10) Put blanking caps on the disconnected electrical connectors (1), (3) and (9).
R 1EFF : 051-099, 106-149, 151-199, 201-299, 1 34-41-37Page 407 1301-399, 401-499, 1Aug 01/05 1 1 1CES 1
R (11) Remove the eight screws (22). **ON A/C ALL
Subtask 34-41-37-020-051
B. Removal of the Wave Guide Switch
(1)
Remove the eight screws (15) and the eight washers (16).
(2)
Hold the wave guide switch (17) and remove the four screws (18) and the eight washers (19).
(3)
Disengage the wave guide switch (17) from its support (20).
(4)
Remove the Mounting tray (21).
1EFF : ALL 1 34-41-37Page 408 1 1 May 01/05 1 1 1CES 1
TASK 34-41-37-400-001
Installation of the Weather Radar Transceiver Mounting Tray (9SQ)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific access platform 1.6 m (5 ft. 3 in.)
B. Expendable Parts
-------------------------------------------------------------------------------
FIG.ITEM |DESIGNATION |IPC-CSN
-------------------------------------------------------------------------------
14 O-rings 34-41-01 02B-120
C. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
34-41-33-400-003 Installation of the Weather Radar Transceiver (1SQ1, 1SQ2)
**ON A/C 001-049, 101-105,
34-41-37-991-001 Fig. 401 R **ON A/C 051-099, 106-149, 201-299, 301-399, 401-499,
34-41-37-991-001-B Fig. 401A
1EFF : ALL 1 34-41-37Page 409 1 1 Aug 01/05 1 1 1CES 1 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
R **ON A/C 151-199,
R 34-41-37-991-001-C Fig. 401B **ON A/C ALL
3. Job Set-up
__________
Subtask 34-41-37-860-050
A. Aircraft Maintenance Configuration
(1)
Make sure that the access platform is in position at the access door 811 in zone 122.
(2)
Make sure that the access door 811 is open.
4. Procedure
_________
Subtask 34-41-37-420-050
A. Installation of the Wave Guide Switch
(1)
Clean the component interface and/or the adjacent area.
(2)
Do an inspection of the component interface and/or the adjacent area.
(3)
Precaution: If you install a new Mounting tray, make sure that you removed the attachment plates (4).
(4)
Clean and inspect the wave guide switch (17) interface and the adjacent area.
(5)
Install the wave guide switch (17) on its support (20).
(6) 中國航空網 m.k6050.com 航空翻譯 www.aviation.cn 本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航3(70)
