R **ON A/C 001-004, 051-060,
Subtask 34-36-11-720-050
C. Do the functional test of the two ILS (para. Identification test with tool) (Ref. TASK 34-36-00-720-001). **ON A/C ALL
R Post SB 34-1147 For A/C 001-004,051-060, Subtask 34-36-11-720-050-A
C. Do the functional test of the two MMRs (para. Identification test with tool) (Ref. TASK 34-36-00-720-002).
1EFF : ALL 1 34-36-11Page 409 1 1 May 01/05 1 1 1CES 1 **ON A/C ALL
5. Close-up
________ Subtask 34-36-11-410-050
A. Close Access
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Close the radome 110AL (Ref. TASK 53-15-11-410-001).
(3)
Remove the access platform(s).
(4)
Remove the warning notice(s).
1EFF : ALL 1 34-36-11Page 410 1 1 May 01/05 1 1 1CES 1
**ON A/C ALL R Post SB 34-1147 For A/C 001-004,051-060, ANTENNA - GPS ACTIVE (43RT1,43RT2) - REMOVAL/INSTALLATION
_________________________________________________________
TASK 34-36-16-000-001
Removal of the GPS Active Antenna (43RT1, 43RT2)
1.
Reason for the Job
__________________
Self Explanatory
2.
Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------
REFERENCE QTY DESIGNATION
-------------------------------------------------------------------------------
No specific blanking caps
No specific circuit breaker(s) safety clip(s)
No specific nonmetallic scraper
No specific access platform 6.0 m (19 ft. 8 in.)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
34-36-16-991-001 Fig. 401
1EFF : ALL 1 34-36-16Page 401 1 1 May 01/05 1 1 1CES 1
3. Job Set-up
__________
Subtask 34-36-16-865-050
A. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU NAV/MMR/1 42RT1 G12
R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
121VU COM NAV/MMR/2 42RT2 L07 **ON A/C 001-049, 051-061, 101-105, 201-203,
121VU COM NAV/MMR/2 42RT2 K09 **ON A/C ALL
Subtask 34-36-16-010-050
B. Get Access
(1) Put the access platform in position at zone 220 to get access to the antenna 43RT1 (43RT2).
4. Procedure
_________ (Ref. Fig. 401/TASK 34-36-16-991-001) R **ON A/C 106-149, 213-299, 301-399, 401-499,
Subtask 34-36-16-020-050-A
A. Removal of the GPS Active Antenna
(1)
Remove the sealant from the screw heads and around the antenna base with a nonmetallic scraper.
(2)
Remove the four screws (2) and pull the antenna (1) away from the structure (3).
1EFF : ALL 1 34-36-16Page 402 1 1 Aug 01/05 1 1 1CES 1
GPS Active Antenna Figure 401/TASK 34-36-16-991-001
1EFF : 1 1R 1CES ALL 1 11 1 34-36-16 Page 403 May 01/05
(3)
Remove the lockwire and disconnect the coaxial connector (4).
(4)
Remove the antenna (1) and put blanking caps on the disconnected coaxial connectors.
NOTE : The coaxial connector (4) must not go into the fuselage.
____ Attach it to the fuselage with masking tape.
(5) Remove and discard the O-ring (5). R **ON A/C 001-049, 051-099, 101-105, 151-199, 201-212,
Subtask 34-36-16-020-050
A. Removal of the GPS Active Antenna
(1)
Remove the sealant from the screw heads and around the antenna base with a nonmetallic scraper.
(2)
Remove the four screws (2) and pull the antenna (1) away from the structure (3).
(3)
Remove the lockwire and disconnect the coaxial connector (4).
(4)
Remove the antenna (1) and put blanking caps on the disconnected coaxial connectors.
NOTE : The coaxial connector (4) must not go into the fuselage.
____ Attach it to the fuselage with masking tape.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM NAVIGATION 導航3(16)
