R (6) Remove the lamp (4) from the lamp holder (5).
R Subtask 33-49-11-420-053-A
R B. Installation of the Lamp
R (1) Install a new lamp (4) on the lamp holder (5).
R (2) Hold the lamp assembly (2).
R R (3) Carefully, put the lamp holder (5) in position on the lamp assembly (2).
R (4) Install the three washers (6) and screws (7).
R (5) Put the lamp assembly (2) in position.
R (6) Tighten the four fasteners (3).
R **ON A/C ALL
Subtask 33-49-11-865-060
C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): FOR 4LX 1LX FOR 3LX 5LX
Subtask 33-49-11-710-053
D. Operational Test of the lighting
(1) Do the operational test of the Wing and Engine Scan Lights (Ref. TASK 33-49-00-710-001).
5. Close-up
________ Subtask 33-49-11-942-054
A. Put the aircraft back to its initial configuration.
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the access platform(s).
EMERGENCY LIGHTING - DESCRIPTION AND OPERATION
______________________________________________
1. General
_______
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
The emergency lighting system is installed to give:
-
illumination of the cabin and the exit areas during emergency conditions,
-
illumination of the escape route over the wings,
-
illumination of the emergency-escape hatch handles at the emergency exits,
-
power supply of the exit location signs and the exit marking signs,
-
power supply to the integral lights of the door escape slides,
-illumination of the Floor-Proximity Emergency-Escape Path-Marking System (FPEEMS).
**ON A/C 301-399,
The emergency lighting system is installed to give:
-illumination of the cabin and the exit areas during emergency conditions,
-
power supply of the exit location signs and the exit marking signs,
-
power supply to the integral lights of the door escape slides,
-illumination of the Floor-Proximity Emergency-Escape Path-Marking System (FPEEMS).
**ON A/C ALL
2. Component Location
__________________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-209,
A. Emergency Power Supply Units (EPSU) The EPSUs control and monitor the emergency lighting system. They are installed in the ceiling of the passenger compartment.
B. Power Supply Units (PSU) The power supply units provide the electrical power for the marking system of the emergency escape path.
C. Cabin Emergency Lights The ceiling emergency lights are installed to give sufficient illumination in an emergency condition. The lights are installed in the ceiling panels of the aisles, cross-aisles and exit areas. The exit marking signs are installed to show the position of the exits. The lights are installed near each passenger/crew door and emergency exit. The exit location signs are installed to show the position of the exit areas. The lights are installed in the aisles.
D. FPEEPMS The FPEEPMS is installed on the floor or on the seats (as applicable) at the aisle and the emergency-exit area. The system provides floor-level illumination of the passenger aisles and escape routes in the event that smoke obscures normal emergency lighting.
E. Integrated Escape Slide Lights The escape slide lights are integrated in the escape slides. They come on when the escape slides are deployed.
R **ON A/C 106-149, 229-299, 401-499,
A. Emergency Power Supply Units (EPSU) The EPSUs control and monitor the emergency lighting system. They are installed in the ceiling of the passenger compartment.
B. Cabin Emergency Lights The ceiling emergency lights are installed to give sufficient illumination in an emergency condition. The lights are installed in the ceiling panels of the aisles, cross-aisles and exit areas. The exit marking signs are installed to show the position of the exits. The lights are installed near each passenger/crew door and emergency exit. The exit location signs are installed to show the position of the exit areas. The lights are installed in the aisles.
C. Photoluminescent Marking System The system consists of a number of flexible photoluminescent strips. They are installed on the floor and on seats at both sides of the aisle and the emergency-exit area. The system provides floor-level illumination of the passenger aisles and escape routes in the event that smoke obscures normal emergency lighting. The photoluminescent marking system supplies sufficient light for eight hours in a dark area when it is fully charged. When the system is fully discharged, a charge time of at least ten minutes with full brightness of the cabin lighting is necessary.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(72)
