-------------------------------------------------------------------------------
PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------**ON A/C ALL
122VU LIGHTING/CABIN/EMER/LT 3WL V07
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 33-51-00-010-050-A
C. Get Access
(1)
Put the stepladder in position:
FOR 10WL
at the left FWD passenger/crew door,
FOR 13WL
at the left AFT passenger/crew door.
(2)
Remove the ceiling panel to get access to the emergency power-supply unit: FOR 10WL remove 221BC at the left FWD passenger/crew door (Ref. TASK 25-23-42-000-001), FOR 13WL remove 261CC at the left AFT passenger/crew door (Ref. TASK 25-23-42-000-002).
**ON A/C 301-399,
Subtask 33-51-00-010-050-B
C. Get Access
(1)
Put the stepladder in position:
FOR 10WL
at the left FWD passenger/crew door,
FOR 11WL
between the rear emergency exit doors,
FOR 12WL
between the rear emergency exit doors,
FOR 13WL
at the left AFT passenger/crew door,
FOR 14WL
between the forward emergency exit doors,
FOR 15WL
between the forward emergency exit doors.
(2)
Remove the ceiling panel to get access to the emergency power-supply unit: FOR 10WL remove 221BC at the left FWD passenger/crew door (Ref. TASK 25-23-42-000-001), FOR 11WL remove 251KC between the rear emergency exit doors (Ref. TASK 25-23-41-000-001), FOR 12WL remove 251KC between the rear emergency exit doors (Ref. TASK 25-23-41-000-001), FOR 14WL remove 231JC between the forward emergency exit doors (Ref. TASK 25-23-41-000-001), FOR 15WL remove 231JC between the forward emergency exit doors (Ref. TASK 25-23-41-000-001), FOR 13WL remove 261CC at the left AFT passenger/crew door (Ref. TASK 25-23-42-000-002).
**ON A/C ALL
4. Procedure
_________
**ON A/C 001-049, 051-099, 101-105, 151-199, 201-299,
Subtask 33-51-00-860-053
A. Preparation for Test
(1)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(2)
Close all passenger/crew doors and emergency exits.
(3)
On the overhead panel 25VU, make sure that the EMER EXIT LT switch 4WL is in the OFF position.
(4)
On the overhead panel 25VU, make sure that the NO SMOKING switch 190RH is in the OFF position.
1EFF : ALL 1 33-51-00Page 543 1 1 Aug 01/05R 1 1 1CES 1
(5)
On the Forward Attendant Panel (FAP) 120RH, make sure that the LIGHT EMER pushbutton switch and its integral light are off.
(6)
Put the warning notice in position internally on the passenger/crew doors and the emergency exits to tell persons not to open the doors and the emergency exits.
(7) Use the digital multimeter (DGTL multimeter) for this test. R **ON A/C 106-149, 301-399, 401-499,
Subtask 33-51-00-860-053-A
A. Preparation for Test
(1)
Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).
(2)
Close all passenger/crew doors and emergency exits.
(3)
On the overhead panel 25VU, make sure that the EMER EXIT LT switch 4WL is in the OFF position.
(4)
On the overhead panel 25VU, make sure that the NO SMOKING switch 190RH is in the OFF position.
(5)
On the FLight Attendant Panel (FAP) 120RH, make sure that the EMER pushbutton switch and its integral light are off.
(6)
Put the warning notice in position internally on the passenger/crew doors and the emergency exits to tell persons not to open the doors and the emergency exits.
(7)
Use the digital multimeter (DGTL multimeter) for this test.
R 1EFF : ALL 1 33-51-00Page 544 1 1 Aug 01/05 1 1 1CES 1
R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 401-499,
Subtask 33-51-00-710-054
B. Test of the door-switch power supplies with the EMER-EXIT LT switch 4WL
WARNING : BEFORE YOU START WORK ON THE DOOR, MAKE SURE THAT:
_______
-
THE EMERGENCY CONTROL HANDLE IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
-
THE PERCUSSION LEVER OF THE DOOR-DAMPER AND EMERGENCY-OPERATION CYLINDER IS IN THE DISARMED POSITION WITH THE SAFETY PIN INSTALLED.
WARNING : DO NOT OPEN THE PASSENGER/CREW DOORS.
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(121)
