(2)
If you do not replace the cracked wing and engine scan light, you can do an alternative repair as follows:
(a)
Clean the surface of the wing and engine scan-light lens with MISCELLANEOUS (Material No. 19-003) made moist with warm soap solution.
(b)
Dry the surface of the wing and engine scan-light lens with a clean MISCELLANEOUS (Material No. 19-003).
(c)
Apply SPECIAL MATERIALS (Material No. 05-065) to cover the crack(s).
NOTE : Make sure that the tape is correctly installed and has no
____ bubbles, wrinkles or tears in it.
(d) Let the tape cure for 15 minutes minimum at a minimum temperature of 15 deg.C (59.00 deg.F).
(3) If it is not necessary to replace the wing and engine scan light , write in the aircraft technical log that the wing and engine scan light is damaged.
5. Close-up
________ Subtask 33-49-00-865-052
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1LX, 5LX.
Subtask 33-49-00-942-051
B. Put the aircraft back to its initial configuration.
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the warning notice(s).
TASK 33-49-00-440-001
Reactivation of the Wing and Engine Scan Light (3LX, 4LX)
1. Reason for the Job
__________________
Refer to the CDL TASK: 33-1
Wing/engine scan light cover 3(4) LX
2. Job Set-up Information
______________________
A. Fixtures, Tools, Test and Support Equipment
-------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific circuit breaker(s) safety clip(s) No specific 1 WARNING NOTICE
B. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
33-49-11-000-001 Removal of the Wing and Engine Scan Light (3LX, 4LX) 33-49-11-400-001 Installation of the Wing and Engine Scan Light (3LX, 4LX)
3. Job Set-up
__________ Subtask 33-49-00-941-051
A. Safety Precautions
(1) On the EXT LT section of the overhead panel 25VU:
-Put a WARNING NOTICE in position to tell persons not to operate the wing and engine scan light.
Subtask 33-49-00-865-053
B. Open, safety and tag this(these) circuit breaker(s):
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU LIGHTING/EXT LT/WING/AND ENG SCAN/R 1LX W03 122VU LIGHTING/EXT LT/WING/AND ENG SCAN/L 5LX W02
4. Procedure
_________ Subtask 33-49-00-440-050
A. Reactivation of the Wing and Engine Scan Light
(1) Replace the wing and engine scan light (Ref. TASK 33-49-11-000-001) and (Ref. TASK 33-49-11-400-001).
5. Close-up
________ Subtask 33-49-00-865-054
A. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1LX, 5LX
Subtask 33-49-00-942-052
B. Put the aircraft back to its initial configuration.
(1)
Make sure that the work area is clean and clear of tool(s) and other items.
(2)
Remove the warning notice(s).
WING AND ENGINE SCAN LIGHTING - ADJUSTMENT/TEST
_______________________________________________
TASK 33-49-00-710-001 Operational Test of the Wing and Engine Scan Lights
1.
Reason for the Job
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光2(68)
