(1) Do the subsequent steps to open the related circuit breaker panel:
 WARNING : BE VERY CAREFUL WHEN YOU DO WORK ON CIRCUIT BREAKER PANELS.
_______ THERE IS A HIGH VOLTAGE BEHIND THESE PANELS.
 (a)
 Release the quick-release fasteners and lower the related circuit breaker panel 2000VU or 2001VU carefully. The circuit breaker panel is held to the adjacent center ceiling panel by a detent hook.

 (b)
 Release the detent hook and lower one side of the related circuit breaker panel until it hangs in the vertical position.

 (2) Do the subsequent steps to remove the StA-PISA:
 (a)
 Identify the electrical connectors (5, 6, 7 - if installed) and make a note of their position before you disconnect them.

 (b)
 Release the related spring latches (4),(8),(9) and carefully disconnect the electrical connectors (5, 6, 7 - if installed) from the StA-PISA (1).

 (c)
 Put blanking caps on the disconnected electrical connectors.

R 1EFF : 106-149, 301-399, 401-499, 1 33-27-41Page 404 1 1 Aug 01/05 1 1 1CES 1

 Stand Alone Passenger Interface and Supply Adapter (StA PISA)
 Figure 401/TASK 33-27-41-991-001

R 1EFF : 106-149, 301-399, 401-499, 1 33-27-41Page 405 1 1 Aug 01/05 1 1 1CES 1

 (d)
 Make a note of the position of the StA-PISA (1) before you remove it.

 (e)
 Make a note of the position of the cable clips which keep the related cable loom in position.

 (f)
 Hold the StA-PISA (1) and remove the screws (2), the washers (3) and the related cable clips.

 (g)
 Remove the StA-PISA (1). NOTE : If you do not install a new StA-PISA directly after the

____ removal, make sure you close the related circuit breaker panel before you leave the A/C.
R 1EFF : 106-149, 301-399, 401-499, 1 33-27-41Page 406 1 1 Aug 01/05 1 1 1CES 1 TASK 33-27-41-400-001

 Installation of the Stand Alone Passenger Interface and Supply Adapter (StA PISA) WARNING : MAKE SURE THAT NO AC OR DC POWER IS CONNECTED TO THE AIRCRAFT
_______ ELECTRICAL CIRCUITS. THERE IS A RISK OF ELECTROCUTION IF THE AC OR DC POWER STAYS CONNECTED.
 1.
 Reason for the Job

__________________
 Self Explanatory

 2.
 Job Set-up Information

______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific warning notice
 No specific access platform 0.5 m (1 ft. 8 in.)
 No specific 1 STEPLADDER 0.5 M (1.6 FT)

 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
Material No. 16-021  F ASNB70720 FLEXIBLE POLYURETHANE (Ref. 20-31-00)
R 1EFF : 106-149, 301-399, 401-499, 1 33-27-41Page 407 1 1 Aug 01/05 1 1 1CES 1 C. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
23-73-00-740-010 Interface and Power-Up Test of the Cabin Intercommunication Data System (CIDS) via the CFDS 24-41-00-861-002 Energize the Aircraft Electrical Circuits from the External Power 24-41-00-862-002 De-energize the Aircraft Electrical Circuits Supplied from the External Power 33-27-41-991-001 Fig. 401
 3. Job Set-up
__________
 Subtask 33-27-41-860-050
 A. Aircraft Maintenance Configuration
 (1)
 Make sure that the related circuit breaker panel is disengaged and lowered.

 (2)
 Make sure that the STEPLADDER 0.5 M (1.6 FT) is below the related circuit breaker panel.

 (3)
 Make sure that the access platform is in position at the access door 121AL.

 (4)
 Make sure that the access door 121AL is open.

 (5)
 Make sure that the external power connector is not connected to the aircraft receptacle.

 (6)
 Make sure that a warning notice is in position on the access door 121AL to tell persons not to use the external power receptacle.

 (7)
 In the cockpit, on the overhead ELEC panel 35VU, make sure that these pushbutton switches are released:

 -BAT 1, BAT 2,
 -APU GEN,
 -GEN 1, GEN 2,
 -EXT PWR.
R 1EFF : 106-149, 301-399, 401-499, 1 33-27-41Page 408 1 1 Aug 01/05 1 1 1CES 1
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LIGHTS 燈光1(99)