曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (2) Do again the test procedure in Para. 4.G., steps 2. thru 9. 
R R  NOTE : Make sure that the applicable MLG door is open before you do____ the test procedure again.
 Subtask 32-31-00-865-104
 L. Open, safety and tag this(these) circuit breaker(s):
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU L/G/LGCIU/SYS1/NORM 1GA C09 121VU HYDRAULIC/LGCIU/SYS1/GRND SPLY 52GA Q34
 Subtask 32-31-00-420-052
 M. Installation of the LGCIU 1
 (1) Install the LGCIU 1 (5GA1) (Ref. TASK 32-31-71-400-001).
 5. Close-up________ 
R  Subtask 32-31-00-080-066 
R  A. Removal of the Test Equipment 
R R  (1) Disconnect and remove the ADAPTER COVER-STATIC PORT equipment from the static probes 7DA2 and 8DA2, and the GROUND PRESSURE GENERATOR. 
R R  (2) Disconnect and remove the ADAPTOR-CHARGING,PITOT PROBE from the pitot probe 9DA2 and the GROUND PRESSURE GENERATOR. 
R R  (3) Remove the colored adhesive tape from the pitot probe 9DA2 drain holes and the AOA sensor 3FP2.

 

 B. Aircraft Maintenance Configuration
 (1)
 On the panel 20VU:

 -set the IR 3 selector switch to the OFF position.

 (2)
 Depressurize the Green Hydraulic system (Ref. TASK 29-10-00-864-001).

 (3)
 Connect the isolation coupling of the PTU (Ref. TASK 29-23-00-860-002).

 Subtask 32-31-00-865-105
 C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s): 1GA, 52GA, 7XE.
 Subtask 32-31-00-942-089
 D. Removal of Equipment
 (1) Make sure that the work area is clean and clear of tool(s) and other items.
 Subtask 32-31-00-410-071
 E. Close Access
 (1) Close the applicable MLG doors (Ref. TASK 32-12-00-410-001).
 (2) Close the applicable quick-release door 195BB, 196BB. Subtask 32-31-00-869-110
 F. Flight Configuration Precautions
 (1) Put the aircraft back to the ground configuration (Ref. TASK 32-00-00-860-002).
 1EFF : ALL 1 32-31-00Page 549 1 1 Aug 01/05R 1 1 1CES 1

 **ON A/C 001-049, 051-061, 101-105, 201-203,
 Subtask 32-31-00-942-090
 G. Removal of Equipment
 (1)
 Remove the SAFETY DEVICE - RAT (Ref. TASK 29-22-00-860-002).

 (2)
 Remove the safety barriers.

 (3)
 Remove the warning notice(s).

 (4)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

R **ON A/C 062-099, 106-149, 151-199, 204-299, 301-399, 401-499,
 Subtask 32-31-00-942-090-A
 G. Removal of Equipment
 (1)
 Remove the SAFETY DEVICE - RAT (Ref. TASK 29-22-00-860-008).

 (2)
 Remove the safety barriers.

 (3)
 Remove the warning notice(s).

 (4)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 1EFF : ALL 1 32-31-00Page 550 1 1 Aug 01/05 1 1 1CES 1 **ON A/C ALL

 TASK 32-31-00-710-005- 02
 Operational Check to Ensure Safety Valve Closes at 260 kts
 WARNING : PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU
_______ START A TASK ON OR NEAR:
 -
THE FLIGHT CONTROLS

 -
THE FLIGHT CONTROL SURFACES

 -
THE LANDING GEAR AND THE RELATED DOORS

 -COMPONENTS THAT MOVE.
 WARNING : MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING
_______ GEAR.
 WARNING : MAKE SURE THAT THE TRAVEL RANGES OF THE LANDING GEAR DOORS ARE CLEAR.
_______
 1. Reason for the Job
__________________
 Refer to the MPD TASK: 323100-04 Operational Check to Ensure Safety Valve Closes at 260 kts using the GND PWR Contactor (3XG) Override Box.
 NOTE : This task is an alternative procedure to:
____
 - operational check to ensure safety valve closes at 260 kts using the APU to energize the electrical circuits or
 - operational check to ensure safety valve closes at 260 kts using the aircraft batteries and electrical ground power.
 1EFF : ALL 1 32-31-00Page 551 1 1 May 01/05R 1 1 1CES 1

 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM LANDING GEAR 起落架4(71)