曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

_______ MATERIAL/S. USE PROTECTIVE CLOTHING, RUBBER GLOVES, GOGGLES AND A MASK.
 WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK
_______ AREA WHEN YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
 (1)
 Lift the toilet seat cover (1) and the toilet seat (2).

 (2)
 Use a emery cloth, grade 320-400 to remove old adhesive from the area to be repaired on the toilet seat (2).

 (3)
 Use the CLEANING AGENTS (Material No. 11-010) and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003) to clean the area to be repaired on the toilet seat (2).

 (4)
 Apply the Sicomet 85 to the surface of the new Buffer PN 11593 (3) to be bonded.

 EFF : ALL

25-00-00Page 888
Aug 01/05
R
 CES

 Toilet Seat Figure 815/TASK 25-00-00-991-022
R  EFF : CES  ALL  25-00-00 Page 889 Aug 01/05 

 

 (5)
 Install the new buffer (3) on the toilet seat (2). NOTE : The minimum time for the adhesive to bond is 1 minute at 23 +3

____
 -3 deg.C (73.40 +5.40 -5.40 deg.F).

 (6)
 Use the MISCELLANEOUS (Material No. 19-003) and a lint-free cotton cloth CLEANING AGENTS (Material No. 11-010) to remove any unwanted adhesive.

 (7)
 Lower the toilet seat (2) and make sure the fit between the seat (2) and the toilet shroud (4) is correct.

 (8)
 Put the WARNING NOTICE in position to tell persons not to use the toilet seat for approximately 1 hour.

 (9)
 Carefully lower the toilet seat cover (1).

 5. Close-up
________ Subtask 25-00-00-942-078
 A. Close-up
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Remove the ground support and maintenance equipment, the special and standard tools and all other items.

 Subtask 25-00-00-862-072
 B. De-energize the ground service network
 (Ref. TASK 24-42-00-862-001).

 EFF : ALL

25-00-00Page 890
Aug 01/05
R
 CES  TASK 25-00-00-340-016

 Repair of the Lavatory Floor Pan
 1. Reason for the Job
__________________
 Self Explanatory
 2. Job Set-up Information
______________________
 A. Fixtures, Tools, Test and Support Equipment
 -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
No specific approved drill No specific drill No specific emery cloth 320-400 grade No specific lint free cloth No specific milling cutter No specific nonmetallic scraper No specific polycarbonat DAN 197/198
 B. Consumable Materials
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
No specific a lint-free cloth Material No. 05-056 D WLB-8-4548.60 GLASSCLOTH (Ref. 20-31-00) Material No. 05-109 D DAN 493 LAMINATE, A/C INTERIOR (Ref. 20-31-00) Material No. 07-012 D DAN 1200 LACQUER OBSOLETE,REPLACE BY 16-047 (Ref. 20-31-00) Material No. 08-001C D DAN 1193-01 LAMINATION RESIN AND HARDENER (Ref. 20-31-00) Material No. 08-017A USA DOD-A-82720 ADHESIVE STRUCTURAL FLEXIBLE (Ref. 20-31-00) Material No. 08-025 D DA-4-653-3-E6 TWO COMPONENT POLYURETHANE ADHESIVE (Ref. 20-31-00)
 Material No. 08-026 ADHESIVE/SEALANT ONE PART,RTV SILICONE RUBBER (Ref. 20-31-00)  -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------

Material No. 11-010 USA TT-I-735 GRADE A ISOPROPYL ALCOHOL (Ref. 20-31-00) Material No. 16-047 F ASNA3687 DECORATIVE PAINT (INTERNAL APPLIC.) (Ref. 20-31-00)
 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001 Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from
 the External Power 25-45-18-000-001 Removal of the Access Door on the Lavatory Front Wall 25-45-18-400-001 Installation of the Access Door on the Lavatory Front
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備1(67)