GLASSCLOTH (Ref. 20-31-00) Material No. 05-057 C Z-18.903 MICROBALLOONS (Ref. 20-31-00) R Material No. 08-010A D DAN 1199-01 EPOXY RESIN AND HARDENER ADHESIVE (Ref. 20-31-00) R Material No. 08-025 D DA-4-653-3-E6 TWO COMPONENT POLYURETHANE ADHESIVE (Ref. 20-31-00) Material No. 08-036 D DAN 1090 POLYESTER FILLER (Ref. 20-31-00) Material No. 11-010 USA TT-I-735 GRADE A ISOPROPYL ALCOHOL (Ref. 20-31-00) Material No. 19-003 USA AMS 3819 LINT-FREE COTTON CLOTH (Ref. 20-31-00)
 EFF : ALL

25-00-00Page 833

 C. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-42-00-861-001  Energize the Ground Service Network from the External Power 24-42-00-862-001 De-energize the Ground Service Network Supplied from the External Power 25-00-00-991-003 Fig. 806 R
 3. Job Set-up
__________
 Subtask 25-00-00-861-055

 A. Energize the ground service network
 (Ref. TASK 24-42-00-861-001).

 Subtask 25-00-00-020-067
 B. If necessary, remove the component you will repair from the aircraft (refer to the related AMM chapter).
 4. Procedure
_________
 Subtask 25-00-00-340-054

 A. Repair of the Surface Damage WARNING : OBEY THE MANUFACTURER'S INSTRUCTIONS WHEN YOU USE THIS/THESE
_______ MATERIAL/S. USE PROTECTIVE CLOTHING, RUBBER GLOVES, GOGGLES AND A MASK.
 EFF : ALL

25-00-00Page 834

 WARNING : MAKE SURE THAT THERE IS A GOOD FLOW OF AIR THROUGH THE WORK_______ AREA WHEN YOU USE SPECIAL MATERIALS. IF YOU GET ONE OF THESE MATERIALS ON YOUR SKIN, IN YOUR MOUTH OR IN YOUR EYES : -FLUSH IT AWAY WITH A FLOW OF CLEAN WATER FOR BETWEEN 10 AND 15 MINUTES. -GET IMMEDIATE MEDICAL AID IF IRRITATION OCCURS. DO NOT BREATHE THE FUMES FROM THE MATERIAL. DO NOT SMOKE WHEN YOU USE THE MATERIAL. DO NOT USE THE MATERIAL NEAR A FLAME, SPARKS OR SOURCES OF HEAT. THESE MATERIALS ARE DANGEROUS : THEY ARE POISONOUS, FLAMMABLE AND SKIN IRRITANTS.
 (1) Clean the damaged area with CLEANING AGENTS (Material No. 11-010) and a lint-free cotton cloth MISCELLANEOUS (Material No. 19-003). 
R  (2) For damage of 1.0 mm (0.04 in.) and less.
 (a) Prepare the BONDING AND ADHESIVE COMPOUNDS (Material No. 08-036).
 NOTE : Refer to the manufacturers instructions for the correct____ repair procedure.
 (b) Apply the compound to the repair area with a SPATULA - NON METALLIC. 
R R  (3) For damage deeper than 1 mm (0.04 in.) and less than 50 mm (2.0 in.) diameter:
 (a) Mix the volume of 90 parts BONDING AND ADHESIVE COMPOUNDS (Material No. 08-010A) (Araldite AW134) with 10 parts of SPECIAL MATERIALS (Material No. 05-057).
 (b) Mix the weight of 100 parts of the compound and 60 parts of the BONDING AND ADHESIVE COMPOUNDS (Material No. 08-010A) (hardener).
 (c) Apply the compound to the repair area with a SPATULA - NON METALLIC. 
R R  (4) For damage deeper than 1.0 mm (0.04 in.) and more than 50 mm (2.0 in.) diameter: (Ref. Fig. 806/TASK 25-00-00-991-003)
 (a) If the component is cracked, you must stop-drill the ends of the cracks.

 EFF : ALL

25-00-00Page 835

 Repair with Three Patches Figure 806/TASK 25-00-00-991-003
R  EFF : CES  ALL  25-00-00 Page 836 May 01/05 

 (b)
 Make the edges of the damage smooth with emery cloth, 320-400 grade.

 (c)
 Make 3 patches of SPECIAL MATERIALS (Material No. 05-033).

 (d)
 Apply BONDING AND ADHESIVE COMPOUNDS (Material No. 08-025) to the repair.

 (e)
 Apply the patch (3) to the repair.

 (f)
 Apply BONDING AND ADHESIVE COMPOUNDS (Material No. 08-025) to the patch.

 (g)
 Apply the patch (2) to the repair.

 (h)
 Apply BONDING AND ADHESIVE COMPOUNDS (Material No. 08-025) to the patch.

 (i)
 Apply the patch (1) to the repair.

 (j)
 Apply BONDING AND ADHESIVE COMPOUNDS (Material No. 08-025) to the patch.

 (5)
 When the repair is dry, make the repair area smooth with emery cloth, 320-400 grade.

 (6)
 Fill the areas that are not flat with BONDING AND ADHESIVE COMPOUNDS (Material No. 08-010A).

 (7)
 Make the area smooth with emery cloth, grade 320-400.

 (8)
 Clean the repair with CLEANING AGENTS (Material No. 11-010) and a

 MISCELLANEOUS (Material No. 19-003). R
 5. Close-up
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EQUIPMENT/FURNISHINGS 設備1(53)