5. Close-up
________ Subtask 24-21-00-410-080
 A. Close Access
 (1)
 Make sure that the work area is clean and clear of tool(s) and other items.

 (2)
 Make the thrust reverser serviceable (Ref. TASK 78-30-00-081-041).

 (3)
 Close the fan cowl doors (Ref. TASK 71-13-00-410-040):

 -
FOR 1000EM1
 437AL, 438AR,

 -
FOR 1000EM2
 438AL, 448AR.

 (4) Remove the warning notice(s). Subtask 24-21-00-862-062
 B. De-energize the ground service network
 (Ref. TASK 24-42-00-862-001).

 INTEGRATED DRIVE GENERATOR SYSTEM (IDG, GCU) - ADJUSTMENT/TEST______________________________________________________________
 TASK 24-21-00-710-040
 Operational Test of the IDG Disconnect and Reconnect (Reset) Function - Engine Static
 WARNING : BE CAREFUL WHEN YOU WORK ON THE ENGINE COMPONENTS IMMEDIATELY AFTER_______ THE ENGINE IS SHUTDOWN. THE ENGINE COMPONENTS CAN STAY HOT FOR UP TO ONE HOUR.
 1. Reason for the Job__________________
 Refer to the MPD TASK: 242100-04 To do a check of the IDG disconnect system and reset system.
 2. Job Set-up Information______________________ 
R  A. Fixtures, Tools, Test and Support Equipment 
R R R  -------------------------------------------------------------------------------REFERENCE QTY DESIGNATION -------------------------------------------------------------------------------
R R  No specific  Torque Wrench : range 5.00 to 35.00 lbf.in (0.05 to 0.40 m.daN) 
R  B. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
24-41-00-861-002 24-41-00-862-002 31-60-00-860-001 31-60-00-860-002 71-13-00-010-040 71-13-00-410-040  Energize the Aircraft Electrical Circuits from the External PowerDe-energize the Aircraft Electrical Circuits Supplied from the External PowerEIS Start ProcedureEIS Stop ProcedureOpening of the Fan Cowl DoorsClosing of the Fan Cowl Doors 
R  **ON A/C 401-499, 
R  24-21-00-991-922  Fig. 501

R **ON A/C ALL
 3. Job Set-up
__________
 Subtask 24-21-00-861-050
 A. Aircraft Maintenance Configuration
 (1)
 Energize the aircraft electrical circuits
 (Ref. TASK 24-41-00-861-002).

 (2)
 Do the EIS start procedure (Upper ECAM DU and lower ECAM DU only) (Ref. TASK 31-60-00-860-001).

 (3)
 On the ECAM control panel, push the ELEC key to get the ELEC page.

 Subtask 24-21-00-010-050
 B. Open the right fan cowl door (Ref. TASK 71-13-00-010-040):
 -
FOR 1000EM1
 438AR

 -
FOR 1000EM2
 448AR

 Subtask 24-21-00-865-050
 C. Make sure that this(these) circuit breaker(s) is(are) closed:
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU ELEC/IDG2/DISC 2XT T25 122VU ELEC/IDG1/DISC 1XT T24
 Subtask 24-21-00-865-051
 D. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
 -------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------122VU ELEC/GCU/2 2XU2 T27 122VU ELEC/GCU/1 2XU1 T26

 4. Procedure
_________
 CAUTION : ENGAGE THE IDG DISCONNECT MECHANISM WITH THE DISCONNECT RESET RING
_______ BEFORE YOU START THE ENGINE. IF NOT YOU WILL CAUSE DAMAGE TO THE DOG TEETH, AT ENGINE START.
 CAUTION : DO NOT PUSH THE IDG DISCONNECT PUSHBUTTON SWITCH FOR MORE THAN 3
_______ SECONDS. THERE MUST BE AT LEAST 60 SECONDS BETWEEN TWO OPERATIONS OF THE SWITCH. THIS IS TO PREVENT DAMAGE TO THE DISCONNECT SOLENOID WHICH WILL BECOME TOO HOT.

R **ON A/C 001-049, 051-099, 101-149, 151-199, 201-299, 301-399,
 Subtask 24-21-00-710-050
 A. Operational Test of the IDG Disconnect and Reconnect Function
 NOTE : This test is for the system 1. For the other system(s), use the
____
 indications between the parentheses.

 NOTE : Two persons are necessary to do the test: one person holds the
____ disconnect reset ring while the other person pushes the IDG pushbutton switch in the cockpit on the ELEC control panel 35VU.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM ELECTRICAL POWER 電源1(58)