曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

increases nose wheel steering effectiveness. Any deviation from the centerline
during thrust application should be countered with immediate smooth and positive
control inputs. Smooth rudder control inputs combined with small control wheel
inputs result in a normal takeoff with no overcontrolling. Large control wheel
inputs can have an adverse effect on directional control near V1(MCG) due to the
additional drag of the extended spoilers.
Note: With wet or slippery runway conditions, the PM should give special
attention to ensuring the engines have symmetrically balanced thrust
indications.
Rotation and Takeoff
Maintain wings level during the takeoff roll by applying control wheel
displacement into the wind. During rotation continue to apply control wheel in the
displaced position to keep the wings level during liftoff. The airplane is in a
sideslip with crossed controls at this point. A slow, smooth recovery from this
sideslip is accomplished after liftoff by slowly neutralizing the control wheel and
rudder pedals.
Gusty Wind and Strong Crosswind Conditions
For takeoff in gusty or strong crosswind conditions, use of a higher thrust setting
than the minimum required is recommended. When the prevailing wind is at or
near 90° to the runway, the possibility of wind shifts resulting in gusty tailwind
components during rotation or liftoff increases. During this condition, consider the
use of thrust settings close to or at maximum takeoff thrust. The use of a higher
takeoff thrust setting reduces the required runway length and minimizes the
airplane exposure to gusty conditions during rotation, liftoff, and initial climb.
October 31, 2006
777/787 Flight Crew Training Manual
Takeoff and Initial Climb
Copyright © The Boeing Company. See title page for details.
3.18 FCT 777/787 Preliminary (TM)
Avoid rotation during a gust. If a gust is experienced near VR, as indicated by
stagnant airspeed or rapid airspeed acceleration, momentarily delay rotation. This
slight delay allows the airplane additional time to accelerate through the gust and
the resulting additional airspeed improves the tail clearance margin. Do not rotate
early or use a higher than normal rotation rate in an attempt to clear the ground
and reduce the gust effect because this reduces tail clearance margins. Limit
control wheel input to that required to keep the wings level. Use of excessive
control wheel may cause spoilers to rise which has the effect of reducing tail
clearance. All of these factors provide maximum energy to accelerate through
gusts while maintaining tail clearance margins at liftoff. The airplane is in a
sideslip with crossed controls at this point. A slow, smooth recovery from this
sideslip is accomplished after liftoff by slowly neutralizing the control wheel and
rudder pedals.
Reduced Thrust Takeoff
Many operators prefer a less than maximum thrust takeoff whenever performance
limits and noise abatement procedures permit. The reduced thrust takeoff lowers
EGT and extends engine life.
The reduced thrust takeoff may be done using the Assumed Temperature Method,
a Fixed Derate (as installed), or a combination of both (as installed). Regardless
of the method, use the takeoff speeds provided by the airport analysis, FMC,
Flight Planning and Performance Manual (FPPM), AFM, or other approved
source corresponding to the assumed (higher) temperature and/or selected derate.
Assumed Temperature Method (ATM)
This method achieves a takeoff thrust less than the maximum takeoff thrust by
assuming a temperature that is higher than the actual temperature. The thrust
reduction authorized by most regulatory agencies is limited to 25% below the
maximum takeoff thrust.
777-200 - 777-300ER
The primary thrust setting parameter (EPR/N1) is not considered a limitation. If
conditions are encountered during the takeoff where additional thrust is desired,
such as windshear, the crew should not hesitate to manually advance thrust levers
to maximum takeoff thrust.
787-8
The primary thrust setting parameter (TPR/N1) is not considered a limitation. If
conditions are encountered during the takeoff where additional thrust is desired,
such as windshear, the crew should not hesitate to manually advance thrust levers
to maximum takeoff thrust.
October 31, 2006
777/787 Flight Crew Training Manual
Takeoff and Initial Climb
Copyright © The Boeing Company. See title page for details.
FCT 777/787 Preliminary (TM) 3.19
The assumed temperature method of computing reduced thrust takeoff
performance is always conservative and provides performance equal to or better
than the performance obtained if actually operating at the assumed temperature.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：787機組訓練手冊Flight Crew Training Manual 787(38)