曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 b) Make sure that the brake pairs shown in column B release for five seconds and then apply again. c) Make sure that the unit message display is as shown in
 Table 1 while the brake releases and applies. 6) Release the parking brake. 7) Remove the DO-NOT-CLOSE tag and close this circuit breaker
 on the P6 panel:
 a) 6F4, LANDING GEAR PARKING BRAKE VLV 8) Put the BRAKE TEST rotary switch in the NORM position. 9) Remove the pressure from the left hydraulic system
 (AMM 29-11-00/201). 10) Put the L, R and C IRU's in the OFF position.
 S 944-024
 (11) Do the steps in the Return the Airplane to Its Usual Condition paragraph if more maintenance is not necessary.
 

 32-42-03
 ALL  ú ú 01 Page 409 ú May 28/02
 
A
757 MAINTENANCE MANUAL
 TASK 32-42-03-004-025
 5. Antiskid Module Hydraulic Fuse - Removal (Fig. 401)
________________________________________
 A. Procedure
 S 944-026
 (1)  
Do the Prepare for Removal procedure (Ref Par. 2)

 S 034-027

 (2)  
Disconnect the hydraulic line (23 or 38) from the fuse (22 or 37) and put a cap on the hydraulic line. Remove the hydraulic fitting from the fuse and discard the O-ring.

 S 024-028
 CAUTION: DO NOT LET DIRT OR OTHER UNWANTED MATERIAL GET INTO THE
_______ PORTS OF THE FUSE. IF THIS OCCURS, THE SYSTEM CAN MALFUNCTION.
 (3)  
Remove the bolts (3 or 25) and pull the fuse from the module (17 or 34). Put a plug in the port.

 S 034-029

 (4)  
Remove the retainers (20 or 35) and the O-ring (21 or 36) from the fuse (22 or 37). Discard the O-ring.

 TASK 32-42-03-424-030
 6. Antiskid Module Hydraulic Fuse - Installation (Fig. 401)
_____________________________________________
 A. Consumable Materials
 (1)  D00153 Hydraulic Fluid - BMS 3-11
 B. Parts ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT |FIG | ITEM | ................................................................................ | 401 | 20 | Retainer | 32-42-02 | 01 | 175 | | | 21 | Packing (O-Ring) | | | 170 | | | 22 | Valve Assy - Self Resetting Fuse | | | 160 | | | 35 | Retainer | 32-42-02 | 02 | 87 | | | 36 | Packing (O-Ring) | | | 86 | | | 37 | Valve Assy - Self Resetting Fuse | | | 80 | 2......…........…...................................…...........…....….........1
 C. References
 (1)
29-11-00/201, Pressurize/Depressurize Main Hydraulic System

 D.
Access

 (1)  
Location Zones
 143 Left Main Landing Gear Wheel Well
 144 Right Main Landing Gear Wheel Well

 E.
Procedure

 

 32-42-03
 ALL  ú ú 03 Page 410 ú May 28/01
 
A
757 MAINTENANCE MANUAL
 S 434-031 CAUTION: DO NOT LET DIRT OR OTHER UNWANTED MATERIAL GET IN THE PORTS
_______ OF THE FUSE. THIS CAN CAUSE THE MALFUNCTION OF THE UNIT.
 (1)  Lightly lubricate a new O-ring with hydraulic fluid. Install the hydraulic fitting with the new O-ring in the fuse (22 or 37).
 (2)  S 424-032Install the fuse with a new O-ring (21 or 36) and retainers (20 or 35) in the module. Lubricate the O-ring and the retainers with hydraulic fluid before you install them.
 (3)  S 424-033Install the bolts (3 or 25) and tighten to a torque value of 100-110 pound-inches. Install lockwire.
 (4)  S 424-034Connect the hydraulic line (23 or 38) to the fuse (22 or 37).
 (5)  S 864-035For the normal antiskid module, pressurize the right system hydraulic system and reservoir (AMM 29-11-00/201).
 (6)  S 864-036For the alternate antiskid module, pressurize the left hydraulic system and reservoir (AMM 29-11-00/201).
 (7)  S 864-037Push in the brake pedals fully four or more times.
 (8)  S 794-038After five minutes, look at the fuse installation to make sure that there are no hydraulic leaks.
 (9)  S 714-113Do a check of the operation of the brake that gets hydraulic pressure through the hydraulic line with the fuse that you replaced as follows: (a) Push in the brake pedals and make sure that the brake operates.
 NOTE:____ Look to see that the brake wear pin moves when you push in the brake pedal to make sure that the brake operates.

 S 944-040
 (10) Do the Return the Airplane to Its Usual Condition paragraph if it is not necessary to do more maintenance.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 起落架 CHAPTER 32 - LANDING GEAR 3(32)