0.080-0.100 INCH
MAIN LANDING GEAR DOOR SEAL
DOOR CLOSED SENSOR MAIN LANDING GEAR MAIN LANDING(LEFT S10076 SYS 2) DOOR OUTER SKIN GEAR DOOR(RIGHT S10072 SYS 2)
B C
Main Landing Gear Door Closed Sensors
Figure 505
32-61-00
ALL ú ú 01 Page 509 ú Sep 20/92
A
757 MAINTENANCE MANUAL
RETRACT WHEEL WELL ACTUATOR AFT WALL NOSE LANDING GEAR UP/DOWN LOCKED SENSOR (S10065 SYS 1) (S10078 SYS 2)FORWARD LOCK LINK
STRUT DRAG UPPER
SEE A
SEE B ACTUATOR RETRACT
UPPER DRAG STRUT
GEAR UP/DOWN NOSE LANDING LOCKED SENSOR A
FWD INCH 0.04-0.05
NOSE LANDING GEAR LOCK LINK B
Nose Landing Gear Up/Down Locked Sensors Figure 506
WHEEL WELL AFT WALL
AFT LOCK LINK
NOSE LANDING GEAR LOCK LINK
SEE B
FWD
SPRING
AFT LOCK
LINK
FLEXIBLE
CONDUIT
32-61-00
ALL ú ú 01 Page 510 ú Sep 20/92
A
757
MAINTENANCE MANUAL
FWD INBD ASSY (REF) LOCK LINK SEE A (RIGHT S10070 SYS 2) (RIGHT S10057 SYS 1) (LEFT S10074 SYS 2) (LEFT S10061 SYS 1) MAIN LANDING GEAR SENSOR DOWN AND LOCKED
LANDING GEAR LEFT MAIN (RIGHT EQUIVALENT) 0.04-0.07 INCH (1.016-1.778 mm) LOWER LOCK LINK (REF) (REF) TARGET SENSOR UPPER LOCK LINK (REF)
MLG DOWN AND LOCKED SENSORS A-A
(REF) ACTUATOR LOCK
(REF) ASSEMBLY LOCK LINK
(REF) REAR SPAR
MLG DOWN SENSORS AND LOCKED A INBD FWD
A LOCK LINK ASSEMBLY (REF) A
Main Landing Gear Down and Locked Sensor
Figure 507
32-61-00
ALL ú ú 01.1 Page 511 ú Sep 28/02
A
757
MAINTENANCE MANUAL
(8) S 715-192Make sure only one half of each NOSE, LEFT, RIGHT, GEAR, and DOORS light is on.
(9) S 865-184Close this circuit breaker on the P11 panel: (a) 11P28, R IND LTS 1
S 715-016
(10)
Make sure the two halves of the green NOSE, RIGHT, and LEFT lights and each amber GEAR and DOORS light are on.
S 865-017
(11)
Open this circuit breaker on the P11 panel:
(a)
11C30, LANDING GEAR POS SYS 1
S 715-018
(12)
Make sure only one half of each green NOSE, LEFT, and RIGHT lights is on and each amber GEAR and DOORS light is off.
S 865-019
(13)
Close this circuit breaker on the P11 panel:
(a)
11C30, LDG GEAR POS SYS 1
S 865-193
(14)
Look at the overhead circuit breaker panel, P11 at grid location 11C19 and identify the circuit breaker name that is at this location.
S 865-020
(15)
Open these circuit breakers on the P11 panel:
(a)
ON AIRPLANES WITH THE "LANDING GEAR POS SYS 2 ALTN" CIRCUIT BREAKER INSTALLED AT PANEL GRID LOCATION 11C19: 1) 11C19, LANDING GEAR POS SYS 2 ALTN 2) 11S23, LDG GEAR POS SYS 2
(b)
ON AIRPLANES WITHOUT THE "LANDING GEAR POS SYS 2 ALTN" CIRCUIT BREAKER INSTALLED AT PANEL GRID LOCATION 11C19: 1) 11S23, LANDING GEAR POS SYS 2
S 715-021
(16) Make sure only one half of each green NOSE, RIGHT, and LEFT lights is on, and each amber GEAR light is on, and the DOORS lights are off.
32-61-00
ALL ú ú 03 Page 512 ú Jun 20/93
A
757 MAINTENANCE MANUAL
S 865-022
(17)
Close these circuit breakers on the P11 panel:
(a)
ON AIRPLANES WITH THE "LANDING GEAR POS 2 ALTN" CIRCUIT BREAKER INSTALLED AT PANEL GRID LOCATION 11C19: 1) 11C19, LANDING GEAR POS 2 ALTN 2) 11S23, LDG GEAR POS SYS 2
(b)
ON AIRPLANES WITHOUT THE "LANDING GEAR POS 2 ALTN" CIRCUIT BREAKER INSTALLED AT PANEL GRID LOCATION 11C19: 1) 11S23, LANDING GEAR POS SYS 2
S 715-023
(18)
Make sure the two halves of each green NOSE, LEFT, and RIGHT light and each amber GEAR and DOORS light are on.
S 865-024
(19)
Move the control lever for the landing gear to the DN position.
G.
Do a test of the Landing Gear Position Indication and Warning System No. 1 (Fig. 501)
S 865-194
(1) Use the tables that follow to help you find the sensors on the figures.
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 起落架 CHAPTER 32 - LANDING GEAR 3(148)
