曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (7)  S 024-010Remove the strut door (5).
 (8)  S 034-011Remove the nut (22) to disconnect the lever arms (24) from the support beam. Keep the lever arms to use on the installation of the new strut door.
 NOTE:____ This is an interference fit and it may be necessary to use a vise and a puller.

 

 32-12-04
 ALL  ú ú 01 Page 404 ú May 28/99
 
A

757 MAINTENANCE MANUAL
 TASK 32-12-04-404-012
 3. Install the Strut Door for the Main Landing Gear (Fig. 401)
________________________________________________
 A. Parts
 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT |FIG | ITEM | ................................................................................ | 401 | 1 | Bolt | 32-12-04 | 02 | 120 | | | 2 | Washer | | | 125 | | | 3 | Washer | | | 130 | | | 4 | Nut | | | 135 | | | 5 | Strut Door | | |495,500 | | | 6 | Bolt | | | 30 | | | 7 | Washer | | | 35 | | | 8 | Washer | | | 40 | | | 9 | Nut | | | 45 | | | 10 | Bolt | | | 475 | | | 11 | Washer | | | 480 | | | 12 | Washer | | | 485 | | | 13 | Nut | | | 490 | | | 14 | Bolt | | | 355 | | | 15 | Washer | | | 360 | | | 16 | Washer | | | 365 | | | 17 | Nut | | | 375 | | | 18 | Bolt | | | 501 | | | 19 | Washer | | | 502 | | | 20 | Washer | | | 502C | | | 21 | Nut | | | 502E | 2......…........…...................................…...........…....….........1
 

 32-12-04
 ALL  ú
 ú  01  Page 405
 ú  May 28/01 

 
A

757
MAINTENANCE MANUAL

 ~.............................................................................. | AMM | | AIPC | ................. ............................ | FIG | ITEM | NOMENCLATURE | SUBJECT |FIG | ITEM | ................................................................................ | 401 | 22 | Nut | 32-12-04 | 02 | 395 | | | 23 | Washer | | | 390 | | | 24 | Lever Arm | | |400,405 | | | 25 | Bolt | | |615,617 | | | 26 | Washer | | | 625 | | | 27 | Nut | | | 630 | | | 28 | Bolt | | |637,640 | | | 29 | Washer | | |627,645 | | | 30 | Washer | | |622,650 | | | 31 | Nut | | |655,657 | | | 32 | Bolt | | |610,612 | | | 33 | Washer | | | 627 | | | 34 | Nut | | |630,632 | | | 35 | Bolt | | |600,602 | | | 36 | Washer | | |620,627 | | | 37 | Washer | | |622,625 | | | 38 | Nut | | |630,657 | | | 39 | Bolt | | |605,607 | | | 40 | Washer | | |620,627 | | | 41 | Washer | | |622,625 | | | 42 | Nut | | |630,657 | | | 43 | Bolt | | |635,637 | | | 44 | Washer | | |627,645 | | | 45 | Washer | | | 650 | | | 46 | Nut | | |655,657 | | | 47 | Bolt | | | 610 | | | 48 | Washer | | | 625 | | | 49 | Nut | | | 630 | 2......…........…...................................…...........…....….........1
 B. References
 (1)
AMM 32-00-15/201, Landing Gear Door Locks

 (2)
AMM 32-12-00/501, Main Gear Doors

 C.
Access

 (1)  
Location Zones
 731/741 Main Landing Gear (MLG)
 732/742 MLG Body Doors
 733/743 MLG Oleo Doors

 

 

 32-12-04
 ALL  ú ú 01 Page 406 ú May 28/01
 
A

757 MAINTENANCE MANUAL
 D. Install the Strut Door
 S 014-013
 (1)  
Remove the attach bolts for the beam (18, 25, 28, 32, 35, 39, 43, and 47) if attached. This disassembles the support beam for the door from the door (Detail D).

 S 414-014

 (2)  
Install the nut (22), the washer (23), and the cotter pin to connect the lever arms (24) for the door to the support beam. Tighten the nut to 1500-3300 pound-inches (Detail D).
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：757 AMM 飛機維護手冊 起落架 CHAPTER 32 - LANDING GEAR 1(158)