(c)  
‘component’ means any engine, propeller, part or appliance;

(d)  
‘continuing airworthiness’ means all of the processes ensuring that, at any time in its operating life, the aircraft complies with the airworthiness requirements in force and is in a condition for safe operation;

(e)  
‘large aircraft’ means an aircraft, classified as an aeroplane with a maximum take-off mass of more than 5700 kg, or a multi-engined helicopter;

(f)  
‘maintenance’ means any one or combination of overhaul, repair, inspection, replacement, modification or defect rectification of an aircraft or component, with the exception of pre-flight inspection;

(g)  
‘Organisation’ means a natural person, a legal person or part thereof. Such an organisation may be established at more than one location whether or not within the territory of India;

(h)  
‘Pre-flight inspection’ means the inspection carried out before flight to ensure that the aircraft is fit for the intended flight.

(i)  
For the purpose of this CAR, “Light Aircraft” means the following aircrafts

i an aeroplane, sailplane or powered sailplane with a Maximum Take-off Mass (MTOM) less than 1000 kg that is not classified as complex motor-powered aircraft;
ii a balloon with a maximum design lifting gas or hot air volume of not more than 3400 m3 for hot air balloons, 1050 m3 for gas balloons, 300 m3 for tethered gas balloons;
iii an airship designed for not more than two occupants and a maximum design lifting gas or hot air volume  of not more  than 2500 m3 for hot air airships and 1000 m3 for gas airships
(j)  
For the purpose of this CAR, “LSA aircraft” means a light sport aeroplane which has all of the following characteristics: 

i.
Maximum Take-off Mass (MTOM) of not more than 600 kg; 

ii.  Maximum stalling speed in the landing configuration (VS0) of not more than 45 knots Calibrated Airspeed (CAS) at the aircraft’s maximum certificated take-off mass and most critical centre of gravity;
iii. Maximum seating capacity of no more than two persons, including the pilot;
iv.  
Single, non-turbine engine fitted with a propeller;

v.  
Non-pressurized cabin.’

Rev 0, dated 2nd March, 2010

M.4 Continuing Airworthiness Requirements
(a)  
The continuing airworthiness of aircraft and components shall be ensured in accordance with the provisions of this CAR.

(b)  
Organisations and personnel involved in the continuing airworthiness of aircraft and components, including maintenance, shall comply with the provisions of CAR-M, CAR145 and requirements for licensing of aircraft maintenance personnel, as appropriate.

(c)  
By derogation from paragraph (a), the continuing airworthiness of aircraft holding a Ferry Flight Permit shall be ensured on the basis of the specific continuing airworthiness arrangements as defined in the Ferry Flight Permit issued in accordance with CAR Sec-2, Series F Part VII.

M.5 Entry into force
This CAR shall enter into force with effect from 31st July 2010.
Rev 0, dated 2nd March, 2010
SECTION A TECHNICAL REQUIREMENTS
SUBPART A

GENERAL
M.A.101 Scope
This CAR establishes the measures to be taken to ensure that airworthiness is maintained, including maintenance. It also specifies the conditions to be met by the persons or organizations involved in such continuing airworthiness management.
Rev 0, dated 2nd March, 2010
SUBPART B
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS CAR -M(6)