-
aircraft IPC;
-Wiring diagrams;
-Trouble shooting manual;
-Minimum Equipment List (normally on board the aircraft);
-Operations Manual;
-Flight Manual.
4.6 Supply of parts.
The contract should specify whether a particular type of material or component is supplied by the operator or the CAR-145 approved organisation. Attention should be paid on the fact that it is the CAR-145 competence and responsibility to be in any case satisfied that the component in question meets the approved data/standard and to ensure that the aircraft component is in a satisfactory condition for fitment. In other words, there is definitely no way for a CAR-145 organisation to accept whatever he receives from the operator. Storage conditions should also be addressed.
4.7 Pooled parts.
The contract should specify how the subject of pooled parts at line stations should be addressed.
Rev 0, dated 2nd March, 2010
213
4.8 Unscheduled maintenance/Defect rectification.
The contract should specify to which level the CAR-145 approved organisation may rectify a defect without reference to the operator, and what action should be taken in case the defect rectification may not be performed by the CAR-145 approved organisation.
4.9 Deferred tasks.
The use of the operator's MEL and the relation with the operator in case of a defect that cannot be rectified at the line station should be addressed.
4.10 Release to service.
The release to service has to be performed by the CAR-145 approved organisation in accordance with its MOE procedures. The contract should however specify which support forms have to be used (operator's technical log, etc...).
4.11 Exchange of information.
Each time exchange of information between the operator and CAR-145 approved organisation is necessary, the contract should specify what information should be provided and when, how, by whom and to whom it has to be transmitted.
4.12 Meetings.
Before the contract is applicable, it may be beneficial that the technical personnel of both parties that are involved in the application of the contract meet in order to be sure that every point leads to a common understanding of both parties’ duties.
Rev 0, dated 2nd March, 2010
214
SECTION B
PROCEDURE FOR DGCA
SUBPART A
GENERAL
M.B.101 Scope
This Section establishes the administrative requirements to be followed by DGCA for the application and the enforcement of CAR M.
M.B.102 DGCA
General
DGCA shall be responsible for the issuance, continuation, change, suspension or revocation of certificates and for the oversight of continuing airworthiness. DGCA shall establish documented procedures.
Resources
Appropriate staff has been designated to carry out the tasks as detailed in this Section B.
Qualification and training
All staff involved in CAR-M activities have been appropriately qualified and have appropriate knowledge, experience, initial training and continuation training to perform their allocated tasks.
Procedures
DGCA has established procedures detailing how compliance with this CAR is accomplished. The procedures shall be reviewed and amended to ensure continued compliance.
M.B.103 Acceptable means of compliance
When the acceptable means of compliance of this CAR are complied with, the related requirements of this CAR shall be considered as met.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS CAR -M(112)
