11.  
A M.A. Subpart F approved maintenance organisation which employs only one person to both plan and carry out all maintenance can only hold a limited scope of approval rating. The maximum permissible limits are:-

Rev 0, dated 2nd March, 2010 It should be noted that such an organisation may be further limited by DGCA in the scope of approval dependent upon the capability of the particular organisation.
CLASS AIRCRAFT  RATING A2 AEROPLANES  PISTON ENGINED 5700 KG AND BELOW 
CLASS AIRCRAFT  RATING A3 SINGLE ENGINED HELICOPTERS  PISTON ENGINED 3175 KG ANDBELOW 
CLASS AIRCRAFT  RATING A4 AIRCRAFT OTHER THAN A1, A2 AND A3  NO LIMITATION 
CLASS ENGINES  RATING B2 PISTON  LESS THAN 450 HP 
CLASS COMPONENTS RATING OTHER THAN COMPLETE ENGINES OR APUs  C1 TO C20  AS PER CAPABILITY LIST 
CLASS SPECIALISED  D1 NDT  NDT METHOD(S) TO BE SPECIFIED 

Rev 0, dated 2nd March, 2010
Table 1
CLASS  RATING  LIMITATION 
AIRCRAFT  A2 Aeroplanes 5700 kg and below  Will state aeroplane manufacturer or group or series or type and/or the maintenance tasks 
A3 Single engined Heli-copters  Will state helicopter manufacturer or group or series or type and/or the maintenance task(s) 
A4 Aircraft other than A1, A2 and A3  Will state aircraft series or type and/or the maintenance task(s) 
ENGINES  B1 Turbine  Will state engine series or type and/or the maintenance task(s) 
B2 Piston  Will state engine manufacturer or group or series or type and/or the maintenance task(s) 
B3 APU  Will state engine manufacturer or series or type and/or the maintenance task(s) 
COMPONENTS OTHER THAN COMPLETE ENGINES OR APUs  C1 Air Cond & Press  Will state aircraft type or aircraft manufacturer or component manufacturer or the particular component and/or cross refer to a capability list in the exposition and/or the maintenance task(s) 
C2 Auto Flight 
C3 Comms and Nav 
C4 Doors — Hatches 
C5 Electrical Power 
C6 Equipment 
C7 Engine — APU 
C8 Flight Controls 
C9 Fuel — Airframe 
C10 Helicopter — Rotors 
C11 Helicopter — Trans 
C12 Hydraulic 
C13 Instruments 
C14 Landing Gear 
C15 Oxygen 
C16 Propellers 
C17 Pneumatic 
C18 Protection ice/rain/ Fire 
C19 Windows 
C20 Structural 
SPECIALISED SERVICES  D1 Non-Destructive Testing  Will state particular NDT method(s) 

Rev 0, dated 2nd March, 2010
 Section 2 CAR M Appendix V Approval Certificate CAR-M Section A Subpart F Maintenance Organisation
Page 1 of 2
Directorate General of Civil Aviation
India

APPROVAL CERTIFICATE

REFERENCE
Pursuant to DGCA Regulations for the time being in force and subject to the conditions specified below, DGCA hereby certifies
[COMPANY NAME] MAINTENANCE ORGANISATION
as a maintenance organization as referred to in CAR-M Section A Subpart F approved to maintain the products listed in the attached approval schedule and issue related certificates to service using the above reference
CONDITIONS:
1.
This approval is limited to that specified in the scope of approval section of the approved maintenance organisation manual, and

2.
This approval requires compliance with the procedures specified in the approved maintenance organisation manual, and

3.
This approval is valid whilst the approved maintenance organization remains in compliance with CAR-M

4.
Subject to compliance with the foregoing conditions, this approval shall remain valid unless the approval has previously been
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS CAR -M(36)