(a)  
Push the captain's left rudder pedal fully forward and hold in that position. 1) Make sure that the steering collar at the nose gear turns 6

 to 8 degrees from the neutral position. 2) Release the captain's left rudder pedal and permit it to go to the neutral position. 3) Make sure that rig pin R-3 fits loosely in the rudder quadrant. 4) Make sure that the steering collar turns to the neutral position |2.0 degrees.
 S 715-082
 (22)
 Repeat the above check but push the captain's right rudder pedal.

 (a)  
Make sure the results are the same.

 S 095-083
 (23)
 Remove the actuator from the primary nose gear squat sensor (S800).

 S 745-084

 (24)
 Do a bite test of the nose gear steering with the primary and alternate squat sensors deactivated.

 (a)  
Make sure that the status of bit 21 on the CDU display of label 270 on page 1 is a 0 (NG COMPRESSED).

 (b)  
Make sure that the status of bit 21 on the CDU display of label 272 on page 2 is a 0 (NG COMPRESSED).

 (c)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 0 (the two electrical interconnect actuators are NORMAL).

 (25)
 Make sure that NOSE AIR/GROUND DISAGREE is not shown on EICAS.

 S 715-085
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-51-00
 ALL  ú ú 01 Page 522 ú Jun 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 865-086
 (26)
 Move the upper torsion link to the oleo fully extended position.

 S 715-087

 (27)
 Make sure that the steering collar index mark is within |2.0 degrees of the neutral position.

 S 745-088

 (28)
 Do a bite test of the nose gear steering with the torsion link in the fully extended position.

 (a)  
Make sure that the status of bit 19 on the CDU display of label 010 on page 3 is a 0 (the two electrical interconnect actuators are NORMAL).

 (b)  
Make sure that the status of bit 21 on the CDU display of label 270 on page 1 is a 1 (NG NOT COMPRESSED).

 (c)  
Make sure that the status of bit 21 on the CDU display of label 272 on page 2 is a 1 (NG NOT COMPRESSED).

 S 715-089
 (29)
 Do a check of the deactivated NG steering system.

 (a)  
Push the captain's left rudder pedal fully forward and hold in that position.

 (b)  
Make sure that the steering collar index mark is still within |2.0 degrees of zero.

 S 715-090
 (30)
 Repeat the above check but push the captain's right rudder pedal.

 (a)  
Make sure the results are the same.

 S 865-091
 (31)
 Open the 7G25 NOSE GR STRG PRI circuit breaker on the P7 Overhead Circuit Breaker Panel.

 S 865-092

 (32)
 Open the 7G26 NOSE GR STRG ALTN circuit breaker on the P7 Overhead Circuit Breaker Panel.

 (33)
 Move the upper torsion link to the oleo fully compressed position.

 S 865-093
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 32-51-00
 ALL  ú ú 01 Page 523 ú Jun 10/92
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 715-094
 (34)
 Do a check of the rudder pedals with the circuit breakers off.

 (a)  
Push the captain's left rudder pedal fully forward and hold in that position.

 (b)  
Make sure that the steering collar index mark is still within |2.0 degrees of zero.

 S 715-095
 (35)
 Repeat the above check but push the captain's right rudder pedal.

 (a)  
Make sure the results are the same.

 S 865-096
 (36)
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 起落架 LANDING GEAR 8(6)