S 655-028
 (22)
 Pressurize the fueling manifold.

 S 865-029

 (23)
 Make sure that the RESERVE 2 refuel valve indicator light comes on.

 S 865-030

 (24)
 Put the RESERVE 2 refuel valve switch to the CLOSED position.

 S 865-031

 (25)
 Make sure that the RESERVE 2 refuel valve indicator light goes off.

 S 865-032

 (26)
 Move the fuel, if it is necessary, to keep the airplane center of gravity in the correct limits.

 NOTE: The limits are in the Weight and Balance Manual.
____
 S 715-033
 (27)
 Do the procedure again for the No. 3 reserve fuel tank.

 H.
Put the Airplane Back to Its Usual Condition

 S 655-034
 (1)  
Remove the fueling nozzle from the fueling receptacle and install the filler cap.

 S 865-035

 (2)  
Remove the fueling source ground from the airplane
 (AMM 20-41-01/201).

 (3)  
Put the VTO override switch to the OFF position.

 (4)  
Install the VTO switch guard and the retaining screws (2 locations).

 (5)  
Install the FQPU access door and the retaining screws (6 locations).

 S 865-036
 S 415-037
 S 415-038
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-21-12
 ALL  ú ú 06 Page 506 ú Oct 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (6)  S 865-039Make sure that the fuel quantity indicators on the P42 panel do not flash.
 (7)  S 415-040Close the P42 refuel control panel door.
 (8)  S 415-041Close the fueling receptacle access doors.
 (9)  S 095-042Remove the leading edge flap locks (AMM 27-81-00/201).
 S 865-043

 (10) Remove electrical power (AMM 24-22-00/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 28-21-12
 ALL  ú ú 05 Page 507 ú Jun 18/99
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 REFUEL VALVE UNIT - REMOVAL/INSTALLATION
________________________________________
 1.  General_______
 A.  This procedure contains instructions to remove and install the valve unit for a refuel valve assembly.
 B.  There are instructions given for the valve unit at these locations:
 (1)  
The main or reserve tanks

 (2)  
The center wing tank

 C.  
The refuel valves are in each fuel tank, installed on the spar between the refuel manifold and an outlet tube.

 D.  
You can get access to the refuel valves through the applicable fuel tank access doors.

 E.  
Two persons are necessary to do this procedure.

 (1)  
One person must be in the fuel tank to hold the valve unit and to disconnect and connect the fuel tubing.

 (2)  
One person must be out of the fuel tank to remove and install the mounting hardware.

 TASK 28-21-13-004-001
 2.  Main or Reserve Tank Refuel Valve Unit Removal (Fig. 401)______________________________________________
 A.  References
 (1)  
AMM 28-11-00/201, Fuel Tanks

 (2)  
AMM 28-11-02/401, Reserve and Main Tank Access Door

 (3)  
AMM 28-21-02/401, Refuel Valve Control Unit

 (4)  
AMM 28-26-00/201, Defueling

 (5)  
AIPC 28-21-02, Fig. 2

 B.  
Access

 (1)  
Location Zones 545 Inbd Main Tank (Part), Mid Spar to Rear Spar, Left 552 Outbd Main Tank (Part), Mid Spar to Rear Spar, Left 553 Reserve Tank, Front Spar to Rear Spar, Left 645 Inbd Main Tank (Part), Mid Spar to Rear Spar, Right 652 Outbd Main Tank (Part), Mid Spar to Rear Spar, Right 653 Reserve Tank, Front Spar to Rear Spar, Right

 (2)  
Access Panels
 545AB Fuel Tank Access Door
 553BB Fuel Tank Access Door
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 燃油 FUEL 2(48)