(b)  
Install the window retaining clips.

 NOTE: At this time, only tighten the clips sufficiently
____ to keep the seal in its correct location.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 56-21-00
 ALL  ú ú B01 Page 402 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
PASSENGER WINDOW FRAME
OUTER WINDOWPANE
SEAL ALIGNMENT TAB (6 LOCATIONS)
MIDDLE WINDOWPANE
WINDOW RETAINING CLIP COMBINED
(10 LOCATIONS) SEAL/SPACER
SEE B
CLIP ADJUSTING SCREW CLIP (EXAMPLE)
(10 LOCATIONS) BREATHER
SEE AHOLE
6 3
SEAL TO THE
WINDOW FRAME 89
OUTER 
WINDOWPANE 
START  1  2  COMBINED 
HERE  SEAL/SPACER 
NOTCH 
CENTER 
LINE 
4  7 

MIDDLE
WINDOWPANE 10
5 CLIP ADJUSTING
SCREW SEQUENCE DIAGRAM TO PASSENGER
WINDOW RETAINING CLIP TIGHTEN THE SCREWS WINDOW FRAME (WITH A NYLON LAYER)
A1
WINDOW RETAINING CLIP WITH RETURN FLANGE
1 USE THIS DIAGRAM AS AN EXAMPLE ONLY.
B
ANY SIMILAR PATTERN TO TIGHTEN THE SCREWS IS SATISFACTORY.
Passenger Cabin Windows Figure 401
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 56-21-00
 ALL  ú ú B01 Page 403 ú Mar 15/95
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (c)  
Make sure the middle pane is in contact with the seal around the entire boundary of the pane.

 (d)  
Pull on the seal if it is necessary to get it in its correct position.

 NOTE: There can be a problem if there is not much of the
____ seal to pull. If this occurs, try to put the seal in the correct position from the inside. If there continues to be a problem with the pane contacting the seal, remove the window pane and install it again.
 CAUTION:_______DO NOT OVER TORQUE THE WINDOW CLIP SCREWS. IF THE WINDOW CLIP SCREWS ARE OVER TORQUED, DEFORMATION OF THE WINDOW PANE WILL OCCUR.
 (e)  Tighten the window clip screws in a sequence similar to Fig. 401 from 12 to 15 pound-inches to keep the seal in the correct position.
 NOTE: Loosen the screws if the seal gets wrinkles in it.
____ If the clips are loose you can increase the torque to a maximum of 25 pound-inches.
 (f)  Some windows use spring clips. These are not tightened to a specific torque value. Tighten the screws to a distance of
 0.320 +/- 0.050 inch (8.13 +/- 1.27 mm) of the clip detail and the top of the window frame upstanding frame. 1) A gap may exist between the clip and the screw-head or
 washer, and either gap is acceptable. Do not exceed 20 pound-inches torque during screw installation.
 S 114-008-B00
 (4)  
Clean the inside surface of the windowpane.

 S 114-009-B00

 (5)  
Put the antistatic agent on the inside surface of the windowpane (Ref 12-16-03/301).

 (6)  
Install the sidewall lining (Ref 25-21-01/001).

 (7)  
Use warm water and the castile soap to clean the outer windowpane.

 S 434-010-B00
 S 114-012-B00
 NOTE: Use a soft, clean cloth to put the soap solution on the
____ windowpane. Use your hand to clean the windowpane. This will keep scratches to a minimum.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 56-21-00
 ALL  ú ú B01 Page 404 ú Mar 12/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 114-013-B00
 (8) Use a damp chamois cloth to dry the window.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 WINDOWS(51)