曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 S 118-014-B00
 (1)  Prepare the window frame for installation.
 (a)  Prepare the part of the window frame where the fairing compound is not there: 1) Lightly sand the area of the window frame.
 NOTE: You do not have to remove the old compound if it is
____ in good condition. If you cannot install the new window flush with the skin, you must remove the old compound.
 WARNING:_______THE CLEANING SOLVENT IS FLAMMABLE. YOU MUST BE CAREFUL WHEN YOU USE THE SOLVENT. IF IT STARTS TO BURN, IT CAN CAUSE INJURY TO PERSONS AND DAMAGE TO EQUIPMENT.
 2)  Just before you apply the fairing compound, clean off the sanded surface with a clean dry cloth and cleaning solvent.
 NOTE: Do not use too much solvent.
____
 (b)  Prepare the window frame for the window from which the used fairing compound is fully removed. 1) Clean the surface of the window frame with a cloth and the
 solvent.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 56-11-11
 ALL  ú ú B01 Page 802 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 2) Dry off the surface, while still wet, with a clean dry cloth. 3) Continue to clean and dry the surface until there is no dirt that you can see.
 WARNING:_______THE ALIPHATIC NAPHTHA IS FLAMMABLE. YOU MUST BE CAREFUL WHEN YOU USE IT. IF IT BURNS, IT CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (c)  Rub the mating surface of the faceplate with a clean cloth and aliphatic naphtha.
 NOTE: Do not use too much aliphatic naphtha.
____
 (d)  
Dry off the surface, while the cleaner is wet, with a cloth that is clean and dry.

 (e)  
To make the removal easy, install the tape on the surfaces that touch the faceplate.

 NOTE: You can use Teflon tape, Teflon that was baked on,
____ Teflon cured at room temperature, or a brush layer of Ivory soap applied with a soft bristle brush.
 S 608-015-B00
 WARNING: THE FAIRING COMPOUNDS AND THE SOLVENT CLEANER ARE POISONOUS AND
_______ AND FLAMMABLE. DO NOT PERMIT THEM TO TOUCH YOUR SKIN FOR A LONG TIME. DO NOT GET THEM IN YOUR EYES. KEEP THEM AWAY FROM SPARKS AND FLAMES. THE FUMES CAN CAUSE INJURY TO PERSONS. THE COMPOUNDS CAN BURN AND CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 CAUTION: DO NOT PERMIT AIR TO BE CAUGHT IN THE COMPOUND WHEN YOU MIX IT.
_______
 (2)  Prepare the fairing compound.
 (a)  You can buy fairing compounds in two part kits that are already measured (Refer to Table I for qualities of the different materials).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 56-11-11
 ALL  ú ú B01 Page 803 ú Nov 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 E. Repair the Fairing Compound on the Window Frame.
 NOTE: You must do steps 1 through 3 during the application time of the
____
 compound - Refer to Table 1.

 S 398-016-B00
 (1)  Apply the fairing compound to the window:
 (a)  Apply the fairing compound with a spatula or an extrusion gun.
 NOTE: You must apply the compound to the areas that are not
____ smooth, the clearances and the voids of the window frame.
 Be careful not to permit air to be caught in the compound. You must not permit air bubbles in the compound.
 (b)  
Make the compound smooth and to the necessary contour.

 (c)  
Move the faceplate to its position in the window frame immediately after you apply the fairing compound.

 (d)  
Push the faceplate lightly against the window frame until high spots on the window frame touch the faceplate.

 (e)  
From the fairing compound you prepared above, apply a sample bead to a piece of scrap metal. 1) Permit the sample bead to cure in the same atmospheric

 conditions as those of the faceplate.
 NOTE: To make the compound cure faster, let warm air flow
____ around the area. Do not let the air temperature be more than 120°F (46°C) around the compound and the metal surfaces.
　
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 WINDOWS(22)