*
 acetone (Ref. 70-30-00)
*
 isopropyl alcohol (Ref. 70-30-00)
*
stoddard solvent (Ref. 70-30-00)
*
ardrox 552 (Ref. 70-30-00)
*
turco ind 79 (Ref. 70-30-00)
*
mag-chem teksol (Ref. 70-30-00)
*
degreasol 99 R (Ref. 70-30-00)
*
mag-chem skysol (Ref. 70-30-00)

『
E 78-31-16Page 401
E May 01/05EE

 F 『
 E C F M E
 E E
 E 56-5B E
 E E
 C. Referenced Information

 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
29-14-00-614-001 Depressurization of the Hydraulic Reservoirs 71-13-00-010-040 Opening of the Fan Cowl Doors 78-30-00-481-041 Make the Thrust Reverser Unserviceable for
 Maintenance 78-31-16-991-300 Fig. 401
 3. Job Set-up
__________
 Subtask 78-31-16-941-050
 A. Safety Precautions
 (1) On the center pedestal, on the ENG panel 115VU:

 (a) Put a warning notice to tell persons not to start the engine.

 (2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.

 (3) On the overhead maintenance panel 50VU:

 (a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.

 (b) Put a warning notice to tell persons not to energize the FADEC 1(2).

 Subtask 78-31-16-010-050
 B. Get Access
 (1) Open the fan cowl doors: (Ref. TASK 71-13-00-010-040)
 FOR 1000EM1
 437AL, 438AR
 FOR 1000EM2
 447AL, 448AR

 (2) Put the access platform in position.

 F 『 EEFF : ALL E Page 40278-31-16
 E E May 01/05 ERE
ECES E

 F  『
 E  C F M  E
 E  E

 E 56-5B E
 E E
 Subtask 78-31-16-040-050

 C. Make the thrust reverser unserviceable (Ref. TASK 78-30-00-481-041). Subtask 78-31-16-614-050
 D. Depressurization of the Hydraulic Reservoirs. WARNING : FAILURE TO SHUT OFF AIRCRAFT HYDRAULIC SUPPLY TO THRUST
_______ REVERSER CAN RESULT IN SERIOUS INJURY TO PERSONNEL.
 (1) For engine 1 depressurize the Green hydraulic reservoir (Ref. TASK 29-14-00-614-001).

 (2) For engine 2 depressurize the Yellow hydraulic reservoir (Ref. TASK 29-14-00-614-001).

 4. Procedure
_________
 (Ref. Fig. 401/TASK 78-31-16-991-300)
 Subtask 78-31-16-020-050

 A. Removal of the Pressure Switch
 (1) Disconnect the pylon electrical harness from the pressure switch.

 (2) Install blanking caps on the electrical connectors.

 (3) Remove the sealant from the HCU and the pressure switch with a plastic scraper.

 (4) Clean and dry the surfaces : WARNING : BEFORE THE USE OF SOLVENT, PROTECTIVE FILM OR SEALANT

_______ CAREFULLY READ THE APPLICABLE "MATERIAL SAFETY DATA SHEET" AND FOLLOW ALL LISTED SAFETY AND HEALTH PRECAUTIONS. USE THESE PRODUCTS IN AN AREA OPENED TO THE AIR AND WEAR PROTECTION GLOVES. THESE PRODUCTS ARE FLAMMABLE AND VAPOR IS DANGEROUS. THEY MAY CAUSE IRRITATION OF EYES, NOSE, THROAT AND SKIN. HIGH CONCENTRATIONS MAY CAUSE WEAKNESS, HEADACHE, NAUSEA, DIZZINESS AND IMPAIRED JUDGEMENT.
 F 『 EEFF : ALL E Page 40378-31-16
 E E May 01/05 ERE ECES E

 F 『 E C F M E E E E 56-5B E

 Pressure Switch
 Figure 401/TASK 78-31-16-991-300

 F 『 EEFF : ALL E Page 40478-31-16
 E E Feb 01/98 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

 (a) Clean any remaining sealant from the surfaces of the HCU and the R pressure switch with acetone (Material No. CP1039) or stoddard R solvent (Material No. CP2011) or ardrox 552 (Material No. CP2559) R or turco ind 79 (Material No. CP2560) or mag-chem teksol R (Material No. CP2566) or degreasol 99 R (Material No. CP2584) or R mag-chem skysol (Material No. CP2656) or isopropyl alcohol
 (Material No. CP1041).
 (b) Dry the surfaces with a clean cloth.
 (5) Remove and discard the safety wire.

 (6) Remove the three bolts which attach the pressure switch to the HCU.

 (7) Remove the pressure switch.

 (8) remove and discard the preformed packing (10) and the backup ring (20).

 F 『 EEFF : ALL E Page 40578-31-16
 E E May 01/05 E E ECES E

 F 『
 E C F M E
 E E
 E 56-5B E
 E E

　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM EXHAUST 1(41)