曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  (4) Do the EIS stop procedure (Ref. TASK 31-60-00-860-002). 
R  (5) De-energize the aircraft electrical circuits (Ref. TASK 24-41-00-862-
R  002). 
R  Subtask 28-11-00-615-060 
R  B. Removal of the Microbiological Particles 
R  (1) Do the procedure for the removal of microbiological particles 
R  (Ref. TASK 28-11-00-600-003). 
R  NOTE : Do this procedure as soon as possible to prevent corrosion of____ 
R  the fuel tank structure. 
R  Subtask 28-11-00-670-068 
R  C. Biocidal Shock Treatment for Heavy Contamination - Using Kathon Biocide 
R  with a Metered Injection Rig 
R  (1) Put MICROBIOLOGICAL CONTAMIN. PROTECT. MATERIALS (Material No. 17-
R  003A) into the METERING EQUIPMENT - BIOCIDE, HAMMONDS FUEL ADDITIVES 
R  INC.(CAGE CODE 0U7J1). 
R  (2) Make sure that the METERING EQUIPMENT - BIOCIDE, HAMMONDS FUEL 
R  ADDITIVES INC.(CAGE CODE 0U7J1) is correctly electrically bonded. 
R  (3) Connect the output side of the METERING EQUIPMENT - BIOCIDE, HAMMONDS 
R  FUEL ADDITIVES INC.(CAGE CODE 0U7J1) to the aircraft. 
R  (4) Connect the fuel tanker to the input side of a METERING EQUIPMENT -
R  BIOCIDE, HAMMONDS FUEL ADDITIVES INC.(CAGE CODE 0U7J1). 
R  (5) Refuel the aircraft with fuel mixed with Kathon at a concentration of 
R  100 ppm (by volume) (Ref. TASK 12-11-28-650-004). 
R  (6) Disconnect the METERING EQUIPMENT - BIOCIDE, HAMMONDS FUEL ADDITIVES 
R  INC.(CAGE CODE 0U7J1) and the tanker from the aircraft.

 

R  (7) Let the fuel stay in the tanks for between 12 and 24 hours. 
R  NOTE : In a high ambient temperature, the soak time must be a minimum____ 
R  of 12 hours. In a low ambient temperature, the soak time must 
R  be a minimum of 24 hours. AIRBUS recommends that you always 
R  let the fuel stay in the tanks for 24 hours. 
R  (8) During the soak time: 
R  - do not move the aircraft 
R  - do not operate the fuel pumps or APU 
R  - do not do water drain tests, a high concentration of biocide will 
R  be in the sample. 
R  (9) After the soak time, the fuel and biocide is burned through the APU 
R  and engines during normal operations. 
R  NOTE : Obey the engine manufacturers restrictions and guidelines for____ 
R  your aircraft. 
R  5. Close-up________ 
R  Subtask 28-11-00-942-115 
R  A. Removal of Equipment 
R  NOTE : For disposal of waste fuel, refer to the local regulations.____ 
R  (1) Make sure that the work area is clean and clear of tool(s) and other 
R  items. 
R  (2) Remove the warning notice(s). 
R  (3) Remove the ground support and maintenance equipment, the special and 
R  standard tools and all other items. 
R  (4) Remove the safety barriers. 
R  Subtask 28-11-00-960-066 
R  B. Replace the Fuel Filter Elements 
R  NOTE : The fuel filter elements must be replaced again after 50 to 75____ 
R  hours of operation. 
R  (1) Replace the No. 1 and 2 engine fuel filter elements again (after 50 
R  to 75 hours operation) (Ref. TASK 73-11-10-920-001).

 

R  (2) Replace the APU fuel filter element again (after 50 to 75 hours 
R  operation): 
R  - for the 131-9(A) APU (Ref. TASK 49-32-41-920-001) 
R  - for the GTCP 36-300 APU (Ref. TASK 49-32-11-610-001) 
R  - for the APS 3200 APU (Ref. TASK 49-32-11-610-002). 
R  Subtask 28-11-00-281-062 
R  C. Contamination Check 
R  (1) Do the sampling procedure again in less than 10 days (but after a 
R  minimum of 5 flights) to check for contamination (Ref. TASK 12-32-28-
R  281-003). 
R  NOTE : AIRBUS recommends that if you get a negligible result, you do____ 
R  not continue to use the biocide treatment.

 

R  TASK 28-11-00-600-010 
R  Biocidal Preventative Treatment for Aircraft in Long-Term Storage - With Fuel 
R  Mixed with Biobor Biocide 
R  1. Reason for the Job__________________ 
R  Do this procedure only when an aircraft is put in long-term storage of 30 
R  days or more. 
R  2. Job Set-up Information______________________ 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM FUEL 燃油1(100)