曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

Release the 4 battery case retaining screws slightly. Make the O-ring slightly
wet and push the O-ring into its location with a thin screwdriver. Tighten the 4
battery case retaining screws.
(13) Remove the battery replacement date label from
the battery case and discard it.
(14) Install the new battery replacement date label you
prepared at step 5.
(15) Do a functional test of the ELT. Refer to Paragraph 3.
AIRCRAFT
DA 40 Series
AMM Equipment/Furnishings
Doc # 6.02.01
Rev. 5 25-60-00 Page 209
20 Sep 2007
B. Jolliet JE2-NG
You must only use the Jolliet battery pack P/N JE2-1978-3. You must change the batteries on or
before the date shown on the batteries.
Detail Steps/Work Items Key Items/References
(1) Position the MANU-OFF/RST-AUTO switch to
OFF.
(2) Remove the ELT from its mounting tray. Refer to Paragraph 2.
(3) Extend the portable antenna by pulling the tab in
"T", which is fixed at its extremity.
(4) Unscrew the two screws located inside the two
holes, at each side of the front of the ELT, holding
together the "head" and the battery pack.
(5) Disconnect the battery by unsnapping the two
press-button type connectors.
(6) Connect the connector of the "head" on the one of
the new battery pack.
% (7) The upper part of the battery pack is sealed on
% the inner lip to ensure tightness. If necessary,
complete with sealant provided with the new
battery pack.
(8) Re-insert the control head on the new battery
pack, and screw in the fixture screws.
(9) Re-install the portable antenna around the ELT
unit as it was before.
(10) Install the ELT. Refer to Paragraph 2.
% (11) Do a functional check of the ELT. Refer to Paragraph 3.
AIRCRAFT
Equipment/Furnishings
DA 40 Series
AMM
Page 210
20 Sep 2007 25-60-00 Doc # 6.02.01
Rev. 5
+
Attaching
Screws
Switch Attachment Nuts
Battery
Top Half of RCPI
% Figure 6: ELT Battery Voltage and Polarity Test (ACK E-01)
% Figure 7: RCPI Battery Installation (ACK E-01)
AIRCRAFT
DA 40 Series
AMM Equipment/Furnishings
Doc # 6.02.01
Rev. 5 25-60-00 Page 211
20 Sep 2007
% C. Artex ME 406, ME 406 ACE
% You must only use a battery pack that is supplied by the equipment manufacturer.
% Note: The battery pack contains components that are sensitive to static electricity. You
% must take electro-static discharge precautions before doing work on the battery
% pack.
% Note: The battery pack is connected to the ELT by a short electrical cable assembly. You
% must take care not to strain this cable when you separate the battery pack from the
% ELT.
%
Detail Steps/Work Items Key Items/References
% (1) Remove the ELT from the airplane ELT
% mounting.
Refer to Paragraph 2.
% (2) Remove the battery pack:
% S Remove the 8 screws from the battery-side
% cover.
% S Carefully move the battery pack a short
% distance clear of the ELT.
% S Disconnect the wiring harness.
% S Move the battery pack clear of the ELT.
%
Refer to Figure 8.
Hold the battery pack to the ELT with
your hand to prevent the battery pack
% separating from the ELT.
%
%
%
(3) Do a visual inspection of the underside of the
% ELT (the battery pack side). Look specially for
% corrosion or other damage to the ELT casing.
% (4) Prepare the new battery pack for installation.
(5) Lay the battery pack on the work surface with
% the batteries facing up.
%
% (6) Install the replacement seal. In the slot along the perimeter housing.
% (7) Position the ELT over the battery pack and plug
% the connector into the battery assembly.
Make sure that the cable is not twisted
and that the connector is correctly
% attached.
% (8) Mate the ELT to the battery. Make sure that the seal is positioned
% correctly.
(9) Install the 8 screws that attach the battery pack
% to the ELT.
%
AIRCRAFT
Equipment/Furnishings
DA 40 Series
AMM
Detail Steps/Work Items Key Items/References
Page 212
20 Sep 2007 25-60-00 Doc # 6.02.01
Rev. 5
% (10) Install the ELT in the airplane mounting and
% attach the Battery Pack Replacement Date label
% to the top surface of the ELT protective cover
% where it can be easily seen.
Refer to Paragraph 2.
%
(11) Record the details of the ELT battery pack
% replacement date in the airplane log-book.
% (12) Do a functional test of the ELT. Refer to Paragraph 3.
%
%
%
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：鉆石40系列AMM 1(146)