曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

exceed the critical angle of attack, or that in all
circumstances, a level or near level pitch attitude is
indicative of a low angle of attack. Recovery should be
practiced first without the addition of power, by merely
relieving enough back-elevator pressure that the stall
is broken and the airplane assumes a normal glide
attitude. The instructor should also introduce the
student to a secondary stall at this point. Stall
recoveries should then be practiced with the addition
of power to determine how effective power will be in
executing a safe recovery and minimizing altitude loss.
Stall accidents usually result from an inadvertent stall
at a low altitude in which a recovery was not
accomplished prior to contact with the surface. As a
preventive measure, stalls should be practiced at an
altitude which will allow recovery no lower than 1,500
feet AGL. To recover with a minimum loss of altitude
requires a reduction in the angle of attack (lowering
the airplane’s pitch attitude), application of power, and
termination of the descent without entering another
(secondary) stall.
USE OF AILERONS/RUDDER IN STALL
RECOVERY
Different types of airplanes have different stall
characteristics. Most airplanes are designed so that the
wings will stall progressively outward from the wing
roots (where the wing attaches to the fuselage) to the
wingtips. This is the result of designing the wings in a
manner that the wingtips have less angle of incidence
than the wing roots. [Figure 4-4] Such a design feature
causes the wingtips to have a smaller angle of attack
than the wing roots during flight.
Figure 4-4. Wingtip washout.
Ch 04.qxd 5/7/04 6:47 AM Page 4-5
4-6
Exceeding the critical angle of attack causes a stall; the
wing roots of an airplane will exceed the critical angle
before the wingtips, and the wing roots will stall first.
The wings are designed in this manner so that aileron
control will be available at high angles of attack (slow
airspeed) and give the airplane more stable stalling
characteristics.
When the airplane is in a stalled condition, the
wingtips continue to provide some degree of lift, and
the ailerons still have some control effect. During
recovery from a stall, the return of lift begins at the tips
and progresses toward the roots. Thus, the ailerons can
be used to level the wings.
Using the ailerons requires finesse to avoid an
aggravated stall condition. For example, if the right
wing dropped during the stall and excessive aileron
control were applied to the left to raise the wing, the
aileron deflected downward (right wing) would
produce a greater angle of attack (and drag), and
possibly a more complete stall at the tip as the critical
angle of attack is exceeded. The increase in drag
created by the high angle of attack on that wing might
cause the airplane to yaw in that direction. This adverse
yaw could result in a spin unless directional control
was maintained by rudder, and/or the aileron control
sufficiently reduced.
Even though excessive aileron pressure may have been
applied, a spin will not occur if directional (yaw)
control is maintained by timely application of
coordinated rudder pressure. Therefore, it is important
that the rudder be used properly during both the entry
and the recovery from a stall. The primary use of the
rudder in stall recoveries is to counteract any tendency
of the airplane to yaw or slip. The correct recovery
technique would be to decrease the pitch attitude by
applying forward-elevator pressure to break the stall,
advancing the throttle to increase airspeed, and
simultaneously maintaining directional control with
coordinated use of the aileron and rudder.
STALL CHARACTERISTICS
Because of engineering design variations, the stall
characteristics for all airplanes cannot be specifically
described; however, the similarities found in small
general aviation training-type airplanes are noteworthy
enough to be considered. It will be noted that the
power-on and power-off stall warning indications will
be different. The power-off stall will have less
noticeable clues (buffeting, shaking) than the
power-on stall. In the power-off stall, the predominant
clue can be the elevator control position (full upelevator
against the stops) and a high descent rate.
When performing the power-on stall, the buffeting will
likely be the predominant clue that provides a positive
indication of the stall. For the purpose of airplane
certification, the stall warning may be furnished either
through the inherent aerodynamic qualities of the
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AIRPLANE FLYING HANDBOOK 飛機飛行手冊上(42)