曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

should note the increased yawing tendency at minimum
control airspeed at high power settings with flaps
fully extended. In some airplanes, an attempt to climb
at such a slow airspeed may result in a loss of altitude,
even with maximum power applied.
Common errors in the performance of slow flight are:
• Failure to adequately clear the area.
• Inadequate back-elevator pressure as power is
reduced, resulting in altitude loss.
• Excessive back-elevator pressure as power is
reduced, resulting in a climb, followed by a rapid
reduction in airspeed and “mushing.”
• Inadequate compensation for adverse yaw during
turns.
• Fixation on the airspeed indicator.
• Failure to anticipate changes in lift as flaps are
extended or retracted.
• Inadequate power management.
• Inability to adequately divide attention between
airplane control and orientation.
SLOW FLIGHT
Low airspeed
High angle of attack
High power setting
Maintain altitude
Figure 4-1. Slow flight—Low airspeed, high angle of attack,
high power, and constant altitude.
Ch 04.qxd 5/7/04 6:46 AM Page 4-2
4-3
STALLS
A stall occurs when the smooth airflow over the
airplane’s wing is disrupted, and the lift degenerates
rapidly. This is caused when the wing exceeds its
critical angle of attack. This can occur at any airspeed,
in any attitude, with any power setting. [Figure 4-2]
The practice of stall recovery and the development of
awareness of stalls are of primary importance in pilot
training. The objectives in performing intentional stalls
are to familiarize the pilot with the conditions that
produce stalls, to assist in recognizing an approaching
stall, and to develop the habit of taking prompt
preventive or corrective action.
Intentional stalls should be performed at an altitude
that will provide adequate height above the ground for
recovery and return to normal level flight. Though it
depends on the degree to which a stall has progressed,
most stalls require some loss of altitude during
recovery. The longer it takes to recognize the
approaching stall, the more complete the stall is likely
to become, and the greater the loss of altitude to
be expected.
RECOGNITION OF STALLS
Pilots must recognize the flight conditions that are
conducive to stalls and know how to apply the
necessary corrective action. They should learn to
recognize an approaching stall by sight, sound, and
feel. The following cues may be useful in recognizing
the approaching stall.
• Vision is useful in detecting a stall condition by
noting the attitude of the airplane. This sense can
only be relied on when the stall is the result of an
unusual attitude of the airplane. Since the airplane
can also be stalled from a normal attitude, vision
in this instance would be of little help in detecting
the approaching stall.
• Hearing is also helpful in sensing a stall condition.
In the case of fixed-pitch propeller airplanes in a
power-on condition, a change in sound due to loss
of revolutions per minute (r.p.m.) is particularly
noticeable. The lessening of the noise made by the
air flowing along the airplane structure as airspeed
decreases is also quite noticeable, and when the
stall is almost complete, vibration and incident
noises often increase greatly.
• Kinesthesia, or the sensing of changes in direction
or speed of motion, is probably the most important
and the best indicator to the trained and
experienced pilot. If this sensitivity is properly
developed, it will warn of a decrease in speed
or the beginning of a settling or mushing of
the airplane.
• Feel is an important sense in recognizing the onset
of a stall. The feeling of control pressures is very
important. As speed is reduced, the resistance to
pressures on the controls becomes progressively
less. Pressures exerted on the controls tend to
become movements of the control surfaces. The
-4 0 5 10 15 20
Angle of Attack in Degrees
Coefficient of Lift (CL)
2.0
1.5
1.0
.5
Figure 4-2. Critical angle of attack and stall.
Ch 04.qxd 5/7/04 6:46 AM Page 4-3
4-4
lag between these movements and the response of
the airplane becomes greater, until in a complete
stall all controls can be moved with almost no
resistance, and with little immediate effect on the
airplane. Just before the stall occurs, buffeting,
uncontrollable pitching, or vibrations may begin.
Several types of stall warning indicators have been
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：AIRPLANE FLYING HANDBOOK 飛機飛行手冊上(40)