8.  
send within 10 days a copy of any airworthiness review certificate issued or extended to the competent authority of the Member State of registry;

9.  
carry out all occurrence reporting mandated by applicable regulations;

10.
inform the competent authority of the Member State of registry whenever the present arrangement is denounced by either party.

5.2. Obligations of the owner:
1.  
have a general understanding of the approved maintenance programme;

2.  
have a general understanding of this Annex (Part-M);

3.  
present the aircraft to the approved maintenance organisation agreed with the approved organisation at the due time designated by the approved organisation’s request;

EC 1056/2008
PART-M Appendices
EC 1056/2008

4.  
not modify the aircraft without first consulting the approved organisation;

5.  
inform the approved organisation of all maintenance exceptionally carried out without the knowledge and control of the approved organisation;

6.  
report to the approved organisation through the logbook all defects found during operations;

7.  
inform the competent authority of the Member State of registry whenever the present arrangement is denounced by either party;

8.  
inform the competent authority of the Member State of registry and the approved organisation whenever the aircraft is sold;

9.  
carry out all occurrence reporting mandated by applicable regulations;

10.
inform on a regular basis the approved organisation about the aircraft flying hours and any other utilisation data, as agreed with the approved organisa-tion;

11.
enter the certificate of release to service in the logbooks as mentioned in point M.A.803(d) when performing pilot-owner maintenance without exceed-ing the limits of the maintenance tasks list as declared in the approved main-tenance programme as laid down in point M.A.803(c);

12.
inform the approved continuing airworthiness management organisation responsible for the management of the continuing airworthiness of the air-craft not later than 30 days after completion of any pilot-owner maintenance task in accordance with point M.A.305(a).

Appendix II
Authorised Release Certificate EASA Form 1
These instructions relate only to the use of the EASA Form 1 for maintenance purposes. Attention is drawn to Appendix I to Annex (Part-21) of Regulation (EC) No 1702/2003 which covers the use of the EASA Form 1 for production purposes.
1.  
PURPOSE AND USE

1.1 The primary purpose of the Certificate is to declare the airworthiness of mainte-nance work undertaken on products, parts and appliances (hereafter referred to as ‘item(s)’).
1.2 Correlation must be established between the Certificate and the item(s). The originator must retain a Certificate in a form that allows verification of the origi-nal data.
1.3 The Certificate is acceptable to many airworthiness authorities, but may be dependent on the existence of bilateral agreements and/or the policy of the airworthiness authority. The ‘approved design data’ mentioned in this Certificate then means approved by the airworthiness authority of the importing country.
1.4 The Certificate is not a delivery or shipping note.
1.5 Aircraft are not to be released using the Certificate.
1.6 The Certificate does not constitute approval to install the item on a particular aircraft, engine, or propeller but helps the end user determine its airworthiness approval status.
1.7 A  mixture of production released and maintenance released items is not permitted on the same Certificate.

2.  
GENERAL FORMAT

2.1 The Certificate must comply with the format attached including block numbers and the location of each block. The size of each block may however be varied to suit the individual application, but not to the extent that would make the Certificate unrecognisable.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：CONTINUING AIRWORTHINESS REQUIREMENTS – PART M 2(18)