MAINTENANCE DOCUMENTS - HOW TO USE THE FIM - FIGURE 5
01-00-00
ALTEON PROPRIETARY - Copyright (c) - See title page for details
737-600/700/800/900 TRAINING MANUAL MAINTENANCE DOCUMENTS -- HOW TO USE THE FIM - FIGURE 6 Figure 6: Subjects in Each FIM Chapter
Figure 6 shows what information is at the front of each ATA chapter of the fault isolation manual. The ATA chapter information also shows in the FIM introduction.
01-00-00
737-600/700/800/900 TRAINING MANUAL
01-00-00-106 Rev 1 12/03/1998
MAINTENANCE DOCUMENTS - HOW TO USE THE FIM - FIGURE 6
01-00-00
ALTEON PROPRIETARY - Copyright (c) - See title page for details
MAINTENANCE DOCUMENTS -- BITE MANUAL General
The BITE manual has the procedures to get fault data from the airplane built in test equipment (BITE). It has these sections:
- How To Use The BITE Manual
- BITE Procedure Index
- Observed Fault List
-BITE procedure tasks.
The BITE manual has clear and easy steps to help you follow procedures and find Fault Isolation Manual (FIM) references. It gives the component location for BITE access. It has BITE procedure tasks for easy BITE instructions. It is smaller and easier to carry than the FIM. The observed fault list and the BITE procedure tasks are same as the FIM only in a smaller format.
How To Use BITE Manual
In the How To Use BITE manual sections you see instructions on how to use the BITE manual.
The How To Use BITE manual section is the same as the How to use the FIM, figure 2 in the fault isolation manual.
BITE Procedure Index
The BITE Procedure Index is a list of all the BITE procedures indexed by LRU and system. It is an easy way to find a procedure.
737-600/700/800/900 TRAINING MANUAL
Observed Fault List
The observed fault list is a system order list of flight deck effects or faults that the flight crew or the ground service crew can see. These are the items in the list:
-Fault description
-Fault code
-FIM task number.
The observed fault list in system order is the same as the observed fault list in system order in the fault isolation manual.
BITE Procedure Tasks
BITE procedure tasks give the BITE procedures for that unit. These BITE procedures are the same as the BITE procedures in the fault isolation manual.
01-00-00
737-600/700/800/900 TRAINING MANUAL
01-00-00-200 Rev 1 12/23/1998
737-600/700/800/900 BITE MANUAL
BITE PROCEDURE INDEX BY LRU/SYSTEM
LRU/SYSTEM SHORTENED NAME TASK
ADF Receiver ADF Receiver 34-57 TASK 801
Air Data Inertial Reference System ADIRS 34-21 TASK 801
Airborne Vibration Monitor System Signal AVM SIG COND 77-31 TASK 801
Conditioner
Antiskid Control Unit ANTISKID 32-42 TASK 801
Auxiliary Power Unit APU 49-60 TASK 801
ATC Transponder ATC XPDR 34-53 TASK 801
Autothrottle System A/T 22-31 TASK 801
Bus Power Control Unit BPCU 24-41 TASK 801
Cabin Pressure Controller CAB PRESS CON 21-31 TASK 801
Cabin Temperature Controller CAB TEMP CONT 21-61 TASK 828
Common Display System CDS 31-62 TASK 801
Compartment Overheat Detection Control Module WING/BODY OHT 26-18 TASK 801
Digital Flight Control System DFCS 22-11 TASK 801
DME Interrogator DME INTRROGTR 34-55 TASK 801
Electrical Meters, Battery, & Galley Power P5-13 24-31 TASK 801
Module
Electronic Engine Controller ENGINE 73-00 TASK 801
Emergency Locator Transmitter ELT 23-24 TASK 801
Engine Accessory Unit ENG ACCY UNIT 78-31 TASK 801
Engine and APU Fire Detection Control Module ENG/APU FIRE 26-10 TASK 801
Flap/Slat Electronics Unit FSEU 27-51 TASK 801
Flight Data Acquisition Unit FDAU 31-31 TASK 801
Flight Management Computer System FMCS 34-61 TASK 801
Fuel Quantity Indicating System FQIS 28-41 TASK 801
Generator Control Unit GCU 24-21 TASK 801
Ground Proximity Computer GROUND PROX 34-46 TASK 801
HF Transceiver HF XCVR 23-11 TASK 801
Instrument Landing System Receiver ILS RECEIVER 24-31 TASK 801
Low Limit (35 Degree F) Controller 35 DEG CONT 21-51 TASK 801
Pack/Zone Temperature Controller PACK/ZN CON 21-62 TASK 801
Proximity Switch Electronics Unit PSEU 32-09 TASK 801
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-600/700/800/900培訓(xùn)手冊 TRAINING MANUAL 1(39)
