73-21-00
 ALL  ú ú N02 Page 10 ú Jun 10/90
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
SEE  T 
SEE  U 
ENGINE 
SPEED CARD (REF) 
ELECTRICAL SYSTEMS CARD FILE M7603 
T 
ENG 1 
EEC/TMC 
DISCRETE 
CARD 
YMLA002  ENG 3 
ENG 2  DISCRETE EEC/TMC 
EEC/TMC  CARD 
DISCRETE  YMLA006 
CARD 
YMLA004  ENG 4 
EEC/TMC 
DISCRETE 
CARD 
YMLA008 

U
Fuel Control System Component LocationFigure 1 (Sheet 10)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 73-21-00
 ALL  ú ú N02 Page 11 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 73-21-00
 ALL  ú ú N02 Page 12 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 73-21-00
 ALL  ú ú N02 Page 13 ú Feb 18/02
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES/MAINTENANCE MANUAL ////////////////////////
C.  There are four pneumatic inputs at the bottom of the EEC; PT5 (PT4.95), PT2, PB, and PAMB. A transducer, installed in the EEC, is included for each pneumatic input. The transducer receives the input, changes it to an electronic signal, and sends it to the channel A and B circuits.
 (1)  
The P5 (P4.95) input is exhaust gas pressure from the engine pressure ratio (PT4.95) probes (AMM 77-11-00/001). The P5 (P4.95) transducer is installed in the channel A half of the EEC and is energized by the channel A power supply.

 (2)  
The PT2 input is compressor inlet total pressure from the PT2/TT2 probe. The P2 transducer is installed in the channel A half of the EEC and is energized by the channel A power supply.

 (3)  
The PB input is burner pressure from a static pressure port installed on the diffuser case at the 1:30 o'clock position. The PB transducer is installed in the channel B half of the EEC and is energized by the channel B power supply.

 (4)  
The PAMB input is ambient pressure from two static pressure ports installed on the outer surface of the fan cowl panel at the 5 and 7 o'clock positions. Tubes from each port come together in the strut where one line brings the pressure signal to the EEC. The PAMB transducer is installed in the channel B half of the EEC and is energized by the channel B power supply.

 (5)  
Each pressure line has a serviceable water trap that is installed on the fan case, below the EEC.

 D.  
There are four electrical connectors on the forward side of the EEC and five electrical connectors on the aft side.

 (1)  
The four electrical connectors on the forward side of the EEC (J5A/F, J6FCU, J7ENG, and J8PWR) are for the channel A inputs and outputs that follow:

 (a)  
J5A/F 1) TRA input 2) TRA excitation 3) Digital data input for the left air data computer (L ADC) 4) Digital data input for the right air data computer (R ADC) 5) Digital data input for the flight management computer (FMC) 6) ARINC digital data output 7) Alternate mode select discrete 8) Two discrete returns 9) Autothrottle armed discrete 10) Four location bit discretes 11) Bump discrete 12) Idle select discrete 13) PT2/TT2 probe heat discrete 14) Maintenance discrete

 (b)  
J6FCU 1) N1 input 2) HPC secondary flow control (left) valve position 3) TVBCA (right) valve position discrete 4) Torque motor output for the stator vane actuator 5) TCC torque motor output 6) FMU torque motor output
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 發動機燃油和控制 1(99)