D.
Do the Test of the Latches on the Pressure Relief Doors (Fig. 501).
S 045-002-N00
WARNING: DO THE THRUST REVERSER DEACTIVATION PROCEDURE TO PREVENT THE
_______ OPERATION OF THE THRUST REVERSER. THE ACCIDENTAL OPERATION OF THE THRUST REVERSER CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
(1) Do this procedure: Thrust Reverser Deactivation for Ground Maintenance (AMM 78-31-00/201).
NOTE: This is only necessary if you will use this procedure for the
____ pressure relief doors on the core cowl panels.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-11-08
ALL ú ú N01 Page 501 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////
FAN COWL PANEL
LATCH TOOL SLOT SEE
PRESSURE RELIEF DOOR FOR THE CORE COWL PANEL
(4 LOCATIONS)
1 0.06 |0.03 INCH (1.5 |0.76 MM) Cowl Panel Pressure Relief Doors B
Figure 501 (Sheet 1)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-11-08
ALL ú ú N01 Page 502 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
WASHER TO ADJUST
UPPER/LOWER SIDE TAPERED
GAP SPACER
SHIM
DOOR
DOOR NUT
(2 LOCATIONS)
SHIM TO ADJUST STEP-HEIGHT (2 LOCATIONS) BOLT PINS ROLL
WASHER
(2 LOCATIONS)
WASHER
2
|0.03 INCH
(|0.76 MM)
BUSHING
HINGE FITTING
OUTSIDE
COWL PANEL
INSIDE
HINGE ASSEMBLY CROSS SECTION
HINGE ASSEMBLY A-A
C
COWL PANEL DOOR
INSIDE (REF)
3. BOLTS WASHERS NUTS
LATCH
2 SKIN GAP TOLERANCE INSTALL AS NECESSARY FOR D
Cowl Panel Pressure Relief Door Details
Figure 501 (Sheet 2)
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-11-08
ALL ú ú N01 Page 503 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / PW4000 SERIES /747-400 / ENGINES /MAINTENANCE MANUAL ////////////////////////
5. PIVOT SUPPORT ASSEMBLY
B71044-10 LOAD TEST TOOL INSTALLATION
Cowl Panel Pressure Relief Door Latch Test Figure 501 (Sheet 3)
G83438
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
71-11-08
ALL ú ú N01 Page 504 ú Oct 10/97
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
S 015-017-N00
(2) Open the latches on the pressure relief door.
(a)
Put the blade of a straight-slot screwdriver into the latch slot (1).
(b)
Move the screwdriver handle to the side to turn the latch (1) to the open position.
S 485-018-N00
(3) Install the load-test-adapter-tool for the latch on the pressure relief door.
(a)
Remove the two latch mounting bolts (3) that are nearest to the edge of the pressure relief door.
(b)
Temporarily fasten the adapter assembly (2) to the door with the bolts (4) that are supplied with the adapter assembly. 1) Put the adapter bolts (4) into the bolt holes that the
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 動力裝置 POWER PLANT 2(86)
