曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 (c)  Make sure the outboard wing LE flap aligns with the adjacent
 flaps.
 (d)  If you will install the rotary actuator on the LE flap at the
 center of the wing, make sure there is no movement of the
 system.
 (e)  Install the drive shafts (7) into the adjacent installed rotary
 actuator to engage the spline to the maximum.
 (f)  Align the bearing retainer (8) with the mounting bolt holes.
 (g)  With the actuator drain (12) pointed in the down direction,
 engage (not fully) the actuator output spline (2) with the flap
 linkage.
 NOTE: The buttons on the internal diameter of the actuator____
 cover will align with the detents on the external
 diameter of actuator housing.
 (h)  Turn the actuator input shaft to align the mounting bolt holes.
 (i)  Use the mounting bolts (3 and 10) or pins to keep the actuator
 aligned.
 (j)  To engage the input spline (9), move the rotary actuator (1) in
 its position while you turn the input shaft lightly to engage
 the nearest spline.
 NOTE: The input shaft must not turn more than 10 degrees in____
 each direction.
 (k)  Install the rotary actuator (1) with eight mounting bolts (3
 and 10), washers (4) and locknuts (5).
 (l)  Tighten the locknuts to 150-200 pound-inches.
 (m)  Install the bonding jumper (11) (flaps 6 thru 10 and 17 thru
 21).
 (n)  Align the drive shaft (7) with the external spline (2) on the
 input shaft.
 (o)  Install two screws (13).
 (p)  Install the lockwire.

 S 094-011
 WARNING: YOU MUST CAREFULLY DO THE STEPS IN THE TASK BELOW TO REMOVE THE
_______ LE FLAP SAFETY LOCKS. THE LE FLAPS CAN MOVE QUICKLY IF YOU DO NOT DO THE STEPS CORRECTLY. THIS CAN CAUSE INJURY TO PERSONS OR DAMAGE TO EQUIPMENT.
 (3)  Do this task: "Safety Lock Removal and Leading Edge Flap Activation" (AMM 27-81-00/201).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-81-07
 ALL  ú ú 02 Page 408 ú Jun 18/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400
MAINTENANCE MANUAL

 S 864-012
 (4)  
Do this task: "Supply Electrical Power" (AMM 24-22-00/201).

 S 864-013

 (5)  
For the applicable system, remove the DO-NOT-CLOSE tags and close these circuit breakers:

 (a)  
P6 Main Power Distribution Panel
 1) 6L21 LE FLAP ELEC CONT GRP B DRIVE 1
 2) 6L22 LE FLAP ELEC CONT GRP A DRIVE 2
 3) 6L23 LE FLAP ELEC CONT GRP A DRIVE 3
 4) 6L24 LE FLAP ELEC CONT GRP A DRIVE 4
 5) 6E3 PRIM LE FLAP CONT GRP A AC
 6) 6E4 PRIM LE FLAP CONT GRP A DC
 7) 6E5 PRIM LE FLAP CONT GRP B AC
 8) 6E6 PRIM LE FLAP CONT GRP B DC

 (b)  
P7 Overhead Circuit Breaker Panel
 1) 7C10 FLT CONT ELEC 2L-AC
 2) 7C11 FLT CONT ELEC 2L-DC
 3) 7C12 FLT CONT ELEC 1L-AC
 4) 7C13 FLT CONT ELEC 1L-DC
 5) 7C14 FLT CONT ELEC 1R-AC
 6) 7C15 FLT CONT ELEC 1R-DC
 7) 7C16 FLT CONT ELEC 2R-AC
 8) 7C17 FLT CONT ELEC 2R-DC

 (c)  
P414 Power Distibution Center - Left
 1) 414A5 LE FLAP ELEC DRIVE 1
 2) 414A2 LE FLAP ELEC DRIVE 4

 (d)  
P415 Power Distribution Center - Right
 1) 415M35 LE FLAP ELEC DRIVE 2
 2) 415B32 LE FLAP ELEC DRIVE 3

 

 S 864-014
 CAUTION: CAREFULLY MONITOR THE FLAP RETRACTION TO PREVENT DAMAGE TO
_______ EQUIPMENT. DO NOT ELECTRICALLY EXTEND OR RETRACT THE FLAPS MORE THAN ONE TIME IN 5 MINUTES. DAMAGE TO THE MOTOR CAN OCCUR IF THE MOTOR BECOMES TOO HOT.
 (6)  
Operate the flaps electrically:

 (a)  
Push the ALTN FLAPS ARM switch to put the flap system in alternate control.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-81-07
 ALL  ú ú 02 Page 409 ú Jun 18/99
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 7(138)