S 485-014-C00

 (3)  
Connect an air pressure source to the nipple for the oil supply pressure on the low oil pressure warning switch.

 D. Do the test for the Low Oil Pressure Warning System
 S 865-015-C00
 (1)  Supply electrical power to the applicable engine.
 (a)  Remove the DO-NOT-OPERATE tag from the BAT switch.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-33-00
 ALL  ú ú C03 Page 502 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
SEE  A 
ELECTRICAL CONNECTOR  OIL SUPPLY PRESSURE TUBE 
OIL PRESSURE TRANSMITTER  PRESSURE LOW OIL SWITCH WARNING 

FWD
ELECTRICAL
CONNECTOR

VENT PRESSURE TUBE FROM THE TGB
A

Low Oil Pressure Warning System Test Connections
Figure 501

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-33-00
 ALL  ú ú C03 Page 503 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 865-016-C00
 (2)  Make sure these circuit breakers are closed:
 (a)  P6 Load Control Center
 1) INDICATOR - MASTER DIM BUS (9 locations)
 2) DIM & TEST

 S 215-017-C00
 (3)  
The amber LOW OIL PRESSURE light on the center instrument panel, P2, must be on.

 S 865-018-C00

 (4)  
Put the LIGHTS switch on the center instrument panel, P2, to the DIM position.

 (a)  The LOW OIL PRESSURE light must come on, dim.
 S 865-019-C00
 (5)  Put the LIGHTS switch to the BRT position.
 (a)  The LOW OIL PRESSURE light must come on, bright.
 S 865-020-C00
 (6)  Slowly increase air pressure to 15.25 psi (105.1 kPa) and monitor the LOW OIL PRESSURE light.
 (a) The light must go off when or before the pressure is at
 15.25 psi (105.1 kPa).
 S 865-021-C00
 (7)  Slowly decrease the air pressure and monitor the Low Oil Pressure light.
 (a)  The light must come on before or when the pressure is 12.25 psi
 (84.4 kPa).
 E. Put the Engine Back to its Usual Condition
 S 085-022-C00
 (1)  
Disconnect the air pressure supply from the low oil pressure warning switch.

 (a)  Discard the O-ring.

 (2)
Lubricate and install a new O-ring on the pressure switch nipple.

 (3)  
Connect the elbow to the low oil pressure warning switch.

 (4)  
Close the left fan cowl panel (AMM 71-11-02/201).

 S 435-023-C00
 S 435-026-C00
 S 415-028-C00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-33-00
 ALL  ú ú C03 Page 504 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 865-029-C00
 (5)  Remove the electrical power.
 (a)  Set the BAT switch on the Electrical Meters Battery and Galley Power Module (P5-13) to the OFF position and install a DO-NOT-OPERATE tag.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-33-00
 ALL  ú ú C02 Page 505 ú Mar 12/00
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 滑油 OIL(62)