曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
(7)  S 428-007-C00Put the tool in the spool sleeve, with the centering pin engaged through the hole in the inner sealing spool.
 (8)  S 428-008-C00Turn the tool and engage it farther in the sleeve until the stops of the handle touch the edge of the sleeve.
 (9)  S 428-009-C00Keep the handle stops against the sleeve while you move the handle to the up position.
 S 428-010-C00

 (10)
 While you keep the handle stops against the sleeve, move the handle to the down position.

 S 038-011-C00

 (11)
 Remove the o-ring installation tool from the lubrication unit.

 S 718-012-C00

 (12)
 Do a check that the inner and outer sealing spools move freely in the lubrication unit housing.

 S 798-013-C00

 (13)
 Do Test No. 3 - Leak Check - Idle Power (AMM 71-00-00/501) with the plug of the magnetic chip detector not installed in the lubrication unit.

 S 438-014-C00

 (14)
 Install the magnetic chip detector in the lubrication unit (AMM 79-21-05/201).

 S 618-015-C00

 (15)
 Fill the engine oil system (AMM 12-13-11/301), if it is necessary.

 S 418-016-C00

 (16)
 Close the left fan cowl panel (AMM 71-11-02/201).

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-21-01
 ALL  ú ú C02 Page 804 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
MAIN OIL/FUEL HEAT EXCHANGER - REMOVAL/INSTALLATION
___________________________________________________
 1.  General
_______
 A.  This procedure contains two tasks. The first task is to remove the Main Oil/Fuel Heat Exchanger. The second task is to install the Main Oil/Fuel Heat Exchanger.
 B.  This procedure removes the servo fuel heater and the main oil/fuel heat exchanger from the engine as one unit.
 TASK 79-21-02-004-001-C00
 2.  Remove the Main Oil/Fuel Heat Exchanger
_______________________________________
 A.  Equipment
 (1) Container - One gallon (4 liter) capacity.
 B.  References
 (1)
AMM 24-22-00/201, Electric Power

 (2)
AMM 71-11-02/201, Fan Cowl Panel

 C.  Access
 (1)  
Location Zones
 506 Engine No. 1
 606 Engine No. 2

 (2)  
Access Panels
 5737L/5746L Engine No. 1 - Fan Cowl Assembly
 5837R/5846R Engine No. 2 - Fan Cowl Assembly

 

 D.  Procedure (Fig. 401)
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-21-02
 ALL  ú ú C02 Page 401 ú Jul 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
SEE  A 
EXCHANGER HEAT OIL/FUEL  HEATER SERVO FUEL "FUEL OUT" TUBE "FUEL IN" TUBE 
NUT AND WASHER (6 LOCATIONS)  "OIL OUT" TUBE 
"OIL IN" TUBE 
DRAIN TUBE FUEL 
FWD
FUEL PUMP 
A
Figure 401 Oil/Fuel Heat Exchanger Installation 

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 79-21-02
 ALL  ú ú C01 Page 402 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
S 864-043-C00
 WARNING: DO NOT TOUCH THE COMPONENTS OF THE OIL SYSTEM IF THE ENGINE IS
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 滑油 OIL(26)