S 024-003-C00
(4)
Do the steps that follow to remove the idle reset solenoid
(Fig. 401):
(a)
Remove the electrical connector D3016 from the solenoid.
(b)
Remove the 4 screws and washers which attach the solenoid to MEC.
(c)
Remove and discard the 3 O-rings.
TASK 73-21-03-404-004-C00
3. Install the Idle Reset Solenoid_______________________________
A. Consumable Materials
(1) Petrolatum - Pure Mineral (CP2102), local purchase
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-03
ALL ú ú C02 Page 401 ú Mar 12/00
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
SEE A
IDLE RESET SEEB
SOLENOID CONNECTOR D3016
INBD
MEC FWD
LOOKING UP
BOTTOM VIEW
A
SCREW,
SOLENOID WASHER
(4 LOCATIONS)
O-RINGS
B
Idle Reset Solenoid Installation Figure 401
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-03
ALL ú ú C01 Page 402 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
B. References
(1)
AMM 71-00-00/501, Power Plant
(2)
AMM 71-11-02/201, Fan Cowl Panel
(3)
AMM 78-31-00/201, Thrust Reverser System
C. Access
(1) Location Zones
506 - Engine No.1
606 - Engine No.2
D. Install the Idle Reset Solenoid
S 424-005-C00
(1) Do the steps that follows to install the idle reset solenoid (Fig. 401):
(a)
Apply a thin layer of petrolatum to the 3 new O-rings, and install in the MEC.
(b)
Put the solenoid on the MEC.
1) Install 4 screws and washers which attach the solenoid to the MEC. a) Tighten the screws to 13-16 pound-inches
(1.5-1.8 Newton meters).
(c) Connect the electrical connector D3016 to the solenoid.
S 414-012-C00
WARNING: OBEY THE INSTRUCTIONS IN THIS PROCEDURE WHEN YOU CLOSE THE
_______ THRUST REVERSERS. IF YOU DO NOT OBEY THE INSTRUCTIONS, INJURIES TO PERSONS OR DAMAGE TO EQUIPMENT CAN OCCUR.
(2)
Close the thrust reverser (AMM 78-31-00/201).
S 414-007-C00
(3)
Close the left fan duct cowl (AMM 71-11-02/201).
S 794-008-C00
(4)
Do a test for the idle speed check (AMM 71-00-00/501).
(a) Examine the solenoid for leaks.
EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú
73-21-03
ALL ú ú C01 Page 403 ú Mar 15/94
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
////////////////////////A / /
CFM56 ENGINES
737-300/400/500/ /MAINTENANCE MANUAL ////////////////////////
POWER MANAGEMENT CONTROL - REMOVAL/INSTALLATION
_______________________________________________
1. General
_______
A. This procedure gives the steps for removal and installation of the power management control (referred to as PMC).
B. You can find the PMC on the right fan case at 2:30 o'clock position.
TASK 73-21-04-004-001-C00
2. Remove the Power Management Control (PMC)
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 發動機燃油和控制(121)
