(b)  
Push the NEXT PAGE key until you find all the GROUND TEST MSG pages.

 (c)  
Make a list of all the CMCS messages, CMCS message numbers, and ATA numbers that show on the GROUND TEST MSG pages.

 (d)  
Go to the CMCS Message Index of the Fault Isolation Manual (FIM) to find the corrective action for each CMCS message.

 F. Put the Airplane in its Usual Condition
 S 865-006
 (1)  Remove the electrical power, if it is not necessary
 (AMM 24-22-00/201).

 TASK 21-44-00-705-007
 3. System Test - Aft Cargo Compartment Heating System
__________________________________________________
 A. Standard Tools and Equipment
 (1)  
Cooling source - ice pack, or an equivalent source which can cool a surface to less than 40°F (4°C).

 (2)  
Heating source - Hot water bottle or an equivalent source which can heat a surface to more than 90°F (32°C).

 B. References
 (1)  
AMM 09-11-00/201, Towing

 (2)  
AMM 24-22-00/201, Manual Control

 (3)  
AMM 32-00-30/201, Landing Gear Door Locks

 (4)  
AMM 32-09-02/201, Air/Ground Relay System

 (5)  
AMM 36-00-00/201, Pneumatic System

 C. Access
 (1)  Location Zone
 136 Wing Landing Gear Well, RH
 138 Body Landing Gear Well, RH
 145 Bulk Cargo Compartment, LH

 D. Prepare for the Test
 S 865-104
 (1)  
Apply electrical power (AMM 24-22-00/201).

 (2)  
Apply pneumatic pressure (AMM 36-00-00/201).

 S 495-108

 (3)  
Make sure the landing gear ground locks are installed (AMM 09-11-00/201).

 S 865-106
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 21-44-00
 ALL  ú ú 05 Page 503 ú Feb 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 S 495-110
 WARNING: REFER TO THE SPECIFIED PROCEDURE TO INSTALL THE DOOR LOCKS
_______ CORRECTLY. THE DOORS CAN CLOSE QUICKLY IF YOU DO NOT INSTALL THE DOOR LOCKS CORRECTLY. THIS CAN CAUSE INJURIES TO PERSONS AND DAMAGE TO THE EQUIPMENT.
 (4)
Install the body and the wing gear door locks (AMM 32-00-30/201).

 S 015-112

 (5)  
Remove the cover plate from the sensor assembly box in the bulk cargo compartment.

 NOTE: The cover plate is on the left sidewall of the bulk cargo
____
 compartment at station 2010.

 S 865-125
 (6) Make sure the Cargo Air Conditioning Flow Selector is set to off.
 E. Do the Test
 S 735-040
 (1)  Do the test of the low temperature switch.
 (a)  
Set the CARGO HEAT switch (installed forward of the bulk cargo door) to the 40°F (5°C) position.

 (b)  
Apply a cooling source to the low temperature switch to decrease the temperature of the switch to less than 40°F (4°C).

 NOTE: The low temperature switch is the center temperature
____ switch in the sensor assembly box.
 (c)  If the temperature in the compartment is more than 90°F (32°C), apply a cooling source to the overheat switch.
 NOTE: The overheat switch is on the left side of the sensor
____
 assembly box.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 21-44-00
 ALL  ú ú 06 Page 504 ú Feb 18/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
747-400 MAINTENANCE MANUAL
 (d)
Set the AFT CARGO HT switch on the P5 overhead panel to ON.

 (e)
Make sure the ON light on the AFT CARGO HT switch comes on.

 (f)
Make sure the override valve and the control valve are open.

 NOTE: The valves are installed on the inboard bulkhead of the
____ right body gear wheel well. The valve position indicator is on the top of the valve actuator.
 (g)  
Make sure air comes from the heat ducts in the aft cargo compartment.
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：747-400 AMM 飛機維護手冊 空調 AIR CONDITIONING 1(156)