曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

 CAUTION:_______USE TWO PEOPLE TO INSTALL THE CROSS BEAM. THE CROSS BEAM CAN BECOME CAUGHT ON THE BUSHINGS AND CAUSE DAMAGE TO THE HINGE FITTING.
 USE CARE AS YOU SLIDE THE CROSS BEAM THROUGH EACH CLEVIS AND ABOVE THE HEAT SHIELD. MAKE SURE THE CROSS BEAM IS FREE TO MOVE. AS THE CROSS BEAM LUG STARTS INTO THE OPPOSITE CLEVIS, DO A CHECK OF THE ALIGNMENT. THE BUSHINGS ON THE CROSS BEAM CAN BE CAUGHT ON THE BUSHINGS OF THE HINGE FITTING AND CAUSE DAMAGE.
 (5)  Slide the cross beam through the hinge clevis.
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-42-13
 ALL  ú ú B01 Page 226 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 422-060-B00
 (6)
Install the bushing, jumper, washer, bolt, and nut.

 S 422-061-B00

 (7)
Install the washer, bolt, and nut.

 S 422-062-B00

 (8)
Install the jumper on the clip.

 S 422-063-B00

 (9)
Install the ball in race.

 S 912-064-B00

 (10)
 If you will not immediately be installing the thrust reverser, safety the ball to the cross beam with a piece of rope.

 S 412-065-B00

 (11)
 Do this task: Put the Airplane Back to Its Usual Condition.

 TASK 54-42-13-202-004-B00
 19. Hinge Fitting Examination, Aft Fitting (Fig. 204)______________________________________
 A. References
 (1) AIPC 54-42-50
 B. Access
 (1)  Location Zones
 500 Left Nacelle
 600 Right Nacelle

 C. Procedure
 S 012-066-B00
 (1)
Do this task: Get Access to the Hinges for the Thrust Reverser.

 (2)
Examine the hinge fitting for damage (SRM 54-50-90).

 S 402-067-B00
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-42-13
 ALL  ú ú B01 Page 227 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 S 402-068-B00
 (3)  Examine the bushings for wear or damage.
 (a)  If the bushings are damaged, replace the bushings (CMM 54-50-01).
 S 412-069-B00
 (4) Do this task: Put the Airplane Back to Its Usual Condition.
 TASK 54-42-13-412-005-B00
 20. Put the Airplane Back to Its Usual Condition (Fig. 201)
____________________________________________
 A. References
 (1)  AMM 78-31-01/401, Thrust Reverser
 B. Access
 (1)  
Location Zones
 500 Left Nacelle
 600 Right Nacelle

 (2)  
Access Panels
 5783L - Left Thrust Reverser
 5883R - Right Thrust Reverser

 

 C. Procedure
 S 412-070-B00
 WARNING: OBEY THE INSTRUCTIONS IN THE PROCEDURE TO INSTALL THE THRUST
_______ REVERSER. IF YOU DO NOT OBEY THE INSTRUCTIONS, UNJURIES TO PERSONS AND DAMAGE TO EQUIPMENT CAN OCCUR.
 (1)  Do the procedure to install the thrust reverser (AMM 78-31-01/401).
 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 54-42-13
 ALL  ú ú B01 Page 228 ú Jul 15/98
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A
737-300/400/500MAINTENANCE MANUAL
 INBOARD FLAP OUTBOARD TRACK FAIRING - MAINTENANCE PRACTICES
___________________________________________________________
 1.  General_______
 A.  There are two tasks in this procedure:
 (1)  
The first task removes the inboard flap, outboard track (IFOT) fairing.

 (2)  
The second task installs the IFOT fairing.

 B.  This fairing is an aerodynamic cover which is installed to the rear spar of the wing.
 TASK 54-51-01-002-001-B00
 2.  Inboard Flap Outboard Track Fairing Removal___________________________________________
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 NACELLES/PYLONS(57)