D.
Access

 (1)  
Location Zone 101 Control Cabin, LH 306 Wing Trailing Edge, Aileron and Control Tab, LH 102 Control Cabin, RH 406 Wing Trailing Edge, Aileron and Control Tab, RH

 E.
Install the Aileron Balance Tab

 S 224-004
 (1)  Do this task: "Aileron Balance Tab Inspection/Check" (Ref 27-11-21/601).
AILERON BALANCE PANEL
TAB ADJUST

Aileron Balance Tab Adjust Weights Location
Figure 401

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-21
 ALL  ú ú 02 Page 402 ú Jul 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
AILERON
BALANCE TAB SEE A
AFT TAB
FAIRING

TAB HINGE
(4 LOCATIONS)

SEE C
FORWARD
A
TAB FAIRING
SECTION

OUTBD
TAB MASTS A SEE B
FWD
A
BALANCE TAB
SHIM AS NECASSARY
AILERON  TAB CONTROL
AILERON
AT LOCATION
HINGE  RODS
WBL 439.04 ONLY
BOLT
WASHER (2 LOCATIONS)
HINGE CENTERLINE NUT WASHER
TAB (2 LOCATIONS)
HINGE TAB MASTS
FWD0.020 INCH OUTBD
TAB MASTS
MAXIMUM
A-A
B
Aileron Balance Tab Installation
Figure 402 (Sheet 1)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-21
 ALL  ú ú 01 Page 403 ú Mar 15/96
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A

737-300/400/500
MAINTENANCE MANUAL

TAB WEIGHT  (LBS)  NO. OF WEIGHTS 
FROM  TO  NECESSARY 
0  1.90  NONE 
1.91  2.00  1 
2.01  2.10  2 
2.11  2.20  3 
2.21  2.30  4 
2.31  2.40  5 
2.41  2.50  6 
2.51  2.60  7 
2.61  3.00  8 

Aileron Balance Tab Installation
Figure 402 (Sheet 2)

EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-21
 ALL  ú ú 01 Page 404 ú Mar 15/91
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
 (2)  S 214-005Examine the data plate on the outboard end of the tab for the necessary number of the tab adjust weights.
 (3)  S 214-006Make sure the balance panel bay has the correct number of the tab adjust weights. (a) If the balance panel bay does not have the correct number of the tab adjust weights, add or remove the weights. (b) Install the bolts in the holes that are not used to attach the weights (Fig. 401, 402).
 (4)  S 644-007Lubricate the hinge bearings with grease.
 (5)  S 424-008Install the balance tab: (a) Put the balance tab in its position. (b) Install the four hinge fittings on the tab with the fittings on the aileron (Fig. 402).
 NOTE:____ The axial (inboard-outboard) play of the aileron tab must be between 0.01 and 0.02 inch.
 (c) (d) (e) (f) (g) (h) (i)  Install the four hinge bolts with two thin washers below each bolt head and one thick washer below the nut.Tighten the nuts to 7-17 pound-inches.Install the four cotter pins.Clean surface to give electrical bonding (SWPM 20-20-00).Install the bonding jumpers with applicable screw, nut, and washers (SWPM 20-20-00 TABLE X).Fillet seal fastener and bonding jumper end with sealant.Apply primer plus enamel to exposed bare metal not covered by faying surfaces.

 EFFECTIVITYùùùùùùùùùùùùùùùùùùùùùùùùùùùùùù. ú

 27-11-21
 ALL  ú ú 02 Page 405 ú Nov 12/01
BOEING PROPRIETARY - Copyright (C) - Unpublished Work - See title page for details.
A 737-300/400/500MAINTENANCE MANUAL
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：737-300 400 500 AMM 飛機維護手冊 飛行操縱 FLIGHT CONTROLS 1(114)