曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

R  ELAC1/SEC1: 
R  - replace the XDCR UNIT-ELEV POS, L (49CE1) (Ref. AMM TASK 27-92-13-
R  000-001) and (Ref. AMM TASK 27-92-13-400-001). 
R  (3) If the test gives the maintenance message L ELEV POS MON XDCR OF 
R  ELAC2/SEC2 
R  (a) Do a check of the wiring of the POS XDCR MON SPLY signal from the 
R  transducer unit (49CE1) plug A to the first terminal block (Ref. 
R  ASM 27-93/08): 
R  - if there is continuity, see Para. (b) 
R  - if there is no continuity, repair the above wiring. 
R  (b) Do a check and repair the wiring of the POS XDCR MON V1, V2 
R  signals from the transducer unit (49CE1) plug A to the first 
R  terminal block (Ref. ASM 27-93/08).
 B. Do the test given in Para. 3.

 

 

 Loss of the Signal of the Left Elevator Position Transducer (MON) by the SEC 2
 1. Possible Causes
_______________
 - SEC-2 (1CE2)

 - wiring of the POS XDCR MON (ANI 2-1) signal from the SEC 2 (1CE2) MON part to the first terminal block

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-90-00-810-822 Loss of the ACS1 Signal of the SEC2 MON Side
 AMM 27-94-34-000-001 Removal of the SEC (1CE1,1CE2,1CE3)
 AMM 27-94-34-400-001 Installation of the SEC (1CE1,1CE2,1CE3)
 AMM 27-96-00-710-020 Operational Test of the Side Stick Assembly

 (Activation for the BITE Test)
 AMM 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning)
 ASM 27-94/08

 3. Fault Confirmation
__________________
 A. Test
 (1) Do the operational test of the side stick assembly (Activation for the BITE test) (Ref. AMM TASK 27-96-00-710-020).
 NOTE : Before you start the operational test procedure, release the
____ FLT CTL/ELAC 1 and FLT CTL/ELAC 2 pushbutton switches (on these pushbutton switches the OFF legends come on).
 (2) Do the BITE test of the EFCS (ground scanning) (Ref. AMM TASK 27-96-00-740-001).
 (a) If the ground scanning gives the maintenance message: SEC2 OR WIRING FROM L ELEV POS MON XDCR

 - refer to Para. Fault Isolation.

 (b) If the ground scanning gives at least two maintenance messages of the list below: SEC2 OR WIRING FROM L B ELEV MODE XDCR 34CE3 SEC2 OR WIRING FROM L ELEV POS MON XDCR SEC2 OR WIRING FROM R B ELEV MODE XDCR 34CE4 SEC2 OR WIRING FROM R ELEV POS MON XDCR SEC2 MON OR INPUT OF THS ACTR XDCR3 9CE

 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-30-00∞∞∞∞∞∞∞∞∞∞Page 229
 Aug 01/00R CES

 

 - do this trouble shooting procedure (Ref. TASK 27-90-00-810-822).
 4. Fault Isolation
_______________
 A. If the test gives the maintenance message:
 SEC2 OR WIRING FROM L ELEV POS MON XDCR

 - replace the SEC-2 (1CE2) (Ref. AMM TASK 27-94-34-000-001) and (Ref. AMM TASK 27-94-34-400-001).
 (1) If the fault continues:
 - do a check and repair the wiring of the POS XDCR MON (ANI 2-1) signal from the SEC 2 (1CE2) MON part to the first terminal block (Ref. ASM 27-94/08).
 B. Do the tests given in Para. 3.
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-30-00∞∞∞∞∞∞∞∞∞∞Page 230
 Aug 01/00R
 CES  Failure of the Left Green Elevator-Servocontrol Servovalve

 

 1. Possible Causes
_______________
 - servovalve of the servocontrol 34CE1

 - wiring of the SV signal from the servocontrol (34CE1) to the first terminal block

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 27-34-51-000-008 Removal of the Elevator Servo Control Actuator Servo Valve AMM 27-34-51-400-003 Installation of the Elevator Servo Control Actuator Servo Valve AMM 27-96-00-710-020 Operational Test of the Side Stick Assembly
 (Activation for the BITE Test)
 AMM 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning)
 ASM 27-93/08
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 飛行操縱 1(47)