1. Possible Causes
_______________
 - ELAC-2 (2CE2) R - MODE XDCR of the servo control (33CE1)
 - wiring of the MODE XDCR SPLY signal from the servo control (33CE1) to the first terminal block

 - wiring of the MODE XDCR VS1, VS2 signal from the servo control (33CE1) to the ELAC 2 (2CE2)

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
27-90-00-810-810 Loss of the ACS2 Signal of the ELAC2 MON Side AMM 27-14-51-000-005 Removal of the Linear Variable-Differential Transformer (LVDT) of the Aileron- Servo Control AMM 27-14-51-400-005 Installation of the Linear Variable-Differential
 Transformer (LVDT) of the Aileron Servo-Control
 AMM 27-93-34-000-001 Removal of the ELAC (2CE1,2CE2)
 AMM 27-93-34-400-001 Installation of the ELAC (2CE1,2CE2)
 AMM 27-96-00-710-020 Operational Test of the Side Stick Assembly

 (Activation for the BITE Test)
 AMM 27-96-00-740-001 BITE Test of the EFCS (Ground Scanning)
 ASM 27-93/03

 3. Fault Confirmation
__________________
 A. Test
 (1) Do the operational test of the side stick assembly (activation for the BITE test) (Ref. AMM TASK 27-96-00-710-020).

 (2) Do the BITE test of the EFCS (ground scanning) (Ref. AMM TASK 27-96-00-740-001).

 (a) If the ground scanning gives the maintenance message: L G AIL MODE XDCR 33CE1 OR INPUT OF ELAC 2

 - refer to the Para. Fault Isolation.

 (b) If the ground scanning gives the maintenance messages: L G AIL MODE XDCR 33CE1 OR INPUT OF ELAC 2 R B AIL MODE XDCR 33CE4 OR INPUT OF ELAC 2

 - refer to this procedure (Ref. TASK 27-90-00-810-810).
 「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞27-10-00∞∞∞∞∞∞∞∞∞∞Page 228
 Feb 01/03 CES

 4. Fault Isolation
_______________

 A. If the test gives the maintenance message: L G AIL MODE XDCR 33CE1 OR INPUT OF ELAC 2 - replace the ELAC-2 (2CE2), (Ref. AMM TASK 27-93-34-000-001) and (Ref. AMM TASK 27-93-34-400-001).
R  (1) If the fault continues: - replace the MODE XDCR of the servo control (33CE1), (Ref. AMM TASK 27-14-51-000-005) and (Ref. AMM TASK 27-14-51-400-005). 
R R R R R R R R R R R R R  NOTE : The resistance of primary (pins A/K and A/L) and secondary____ (pins A/J and A/U) windings of the transducer must be between 30 ohms and 500 ohms. The insulation must be more than 100 Mohms. These values are given for information only. You can use these values to do checks of the component electrical part or of the wiring before you replace the component. But by this procedure, the check of the component mechanical part is not done. For primary winding (power supply): - if you do the resistance check from the avionics compartment, you must disconnect the transducer of the Right Blue Aileron Servo Control.
 (2) If the fault continues:
 (a) Do a check of the wiring of the MODE XDCR SPLY signal from the servo control (33CE1) to the first terminal block, (Ref. ASM 27-93/03): - if there is no continuity, repair the wiring - if there is continuity, see Para. (b).
 (b) Do a check and repair the wiring of the MODE XDCR VS1, VS2 signal from the servo control (33CE1) to the ELAC 2 (2CE2), (Ref. ASM 27-93/03).
 B. Do the test given in Para. 3.

 Failure of the Left Green Aileron Servo Control Servovalve
 1. Possible Causes
_______________
 - ELAC-2 (2CE2)

 - SERVO CTL-L AILERON, INBD G (33CE1)

 - servovalve of the servo control 33CE1

 - wiring POS XDCR signal from the servocontrol (33CE1) to the ELAC 2 (2CE2) COM and MON side

 2. Job Set-up Information
______________________
 A. Referenced Information
 -------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 27-14-51-000-001 Removal of the Aileron Servo Control AMM 27-14-51-000-003 Removal of the Aileron Servo-Control Servovalve AMM 27-14-51-400-001 Installation of the Aileron Servo Control AMM 27-14-51-400-003 Installation of the Aileron Servo-Control Servovalve AMM 27-93-34-000-001 Removal of the ELAC (2CE1,2CE2) AMM 27-93-34-400-001 Installation of the ELAC (2CE1,2CE2) AMM 27-96-00-710-020 Operational Test of the Side Stick Assembly
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 飛行操縱 1(10)