(2) If the circuit breaker is open:
- close it.
(a) If it opens again:
- remove the ACP-CAPT (2RN1) (Ref. AMM TASK 23-51-12-000-001)
- remove the AMU (1RN) (Ref. AMM TASK 23-51-34-000-001)
- close the circuit breaker (4RN).
1_ If the circuit breaker stays closed:
- install the removed LRUs one by one until the circuit
breaker (4RN) opens again:
. (Ref. AMM TASK 23-51-12-400-001) for the ACP-CAPT (2RN1)
. (Ref. AMM TASK 23-51-34-000-001) for the AMU (1RN)
- replace the faulty LRU.
2 If the circuit breaker opens again:
_ - replace the circuit breaker (4RN).
a If the fault continues:
_
- do a check and repair the wiring (from Captain ACP (2RN1) pin A/M and from AMU (1RN) pin AC/1 to the first terminal block) (Ref. ASM 23-51/02)
- install the removed LRUs: . (Ref. AMM TASK 23-51-12-400-001) for the ACP-CAPT (2RN1) . (Ref. AMM TASK 23-51-34-000-001) for the AMU (1RN).
(b) If the circuit breaker stays closed:
- replace the Captain ACP (2RN1) and the AMU (1RN) one by one until the fault is no longer there: . (Ref. AMM TASK 23-51-12-000-001) and (Ref. AMM TASK 23-51-12-400-001) for the ACP-CAPT (2RN1) . (Ref. AMM TASK 23-51-34-000-001) and (Ref. AMM TASK 23-51-34-400-001) for the AMU (1RN).
C. Do the test given in Para. 3.
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-51-00∞∞∞∞∞∞∞∞∞∞Page 228
Nov 01/04R
CES TASK 23-51-00-810-819
Loss of the Power Supply of the ACP 2 and AMU Card 2
1. Possible Causes
_______________
- ACP-F/O (2RN2)
- AMU (1RN)
- C/B-COM/AUDIO/ACP/F/O (5RN)
- wiring
2. Job Set-up Information
______________________
A. Referenced Information
-------------------------------------------------------------------------------REFERENCE DESIGNATION -------------------------------------------------------------------------------
AMM 23-51-00-740-002 BITE Test of the Audio System AMM 23-51-12-000-001 Removal of the Audio Control Panel (ACP) (2RN1, 2RN2, 2RN3, 2RN4, 2RN5) AMM 23-51-12-400-001 Installation of the Audio Control Panel (ACP) (2RN1,
2RN2, 2RN3, 2RN4, 2RN5) AMM 23-51-34-000-001 Removal of the Audio Management Unit (AMU) (1RN) AMM 23-51-34-400-001 Installation of the Audio Management Unit (AMU) (1RN) ASM 23-51/03
3. Fault Confirmation
__________________
A. Test Do the BITE test of the AMU-ACP (Ref. AMM TASK 23-51-00-740-002).
4. Fault Isolation
_______________
A. Table of the circuit breakers used in this procedure:
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------49VU COM/AUDIO/ACP/F/O 5RN G07
B. If the BITE test gives the two maintenance messages AUDIO, NO DATA FROM ACP 2 and AUDIO MANAGEMENT UNIT:
- do a check of the circuit breaker (5RN) status.
(1) If the circuit breaker is closed:
- replace the C/B-COM/AUDIO/ACP/F/O (5RN).
(a) If the fault continues:
- do a check and repair the wiring from the circuit breaker (5RN) to the first terminal block (Ref. ASM 23-51/03).
「一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一一1 EFF : ALL ∞∞23-51-00∞∞∞∞∞∞∞∞∞∞Page 229
Aug 01/01R CES
(2) If the circuit breaker is open:
- close it.
(a) If it opens again:
- remove the ACP-F/O (2RN2) (Ref. AMM TASK 23-51-12-000-001)
- remove the AMU (1RN) (Ref. AMM TASK 23-51-34-000-001)
- close the circuit breaker (5RN).
1_ If the circuit breaker stays closed:
- install the removed LRUs one by one until the circuit
breaker (5RN) opens again:
. (Ref. AMM TASK 23-51-12-400-001) for the ACP-F/O (2RN2)
. (Ref. AMM TASK 23-51-34-000-001) for the AMU (1RN)
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320 Trouble Shooting Manual 排故手冊 COMMUNICATIONS 通訊2(12)
