R No specific Torque Wrench : range 0.00 to 1.20 m.daN R (0.00 to 9.00 lbf.ft) No specific Torque Wrench : range 2.00 to 20.00 m.daN
(15.00 to 150.00 lbf.ft)
B. Referenced Information
-------------------------------------------------------------------------------
REFERENCE DESIGNATION
-------------------------------------------------------------------------------
12-12-29-611-001 Fill the Hydraulic Fluid Reservoir with a Hand Pump 12-12-29-611-002 Fill the Hydraulic Fluid Reservoir with a Hydraulic Service Cart 29-00-00-864-001 Put the Related Hydraulic System in the Depressurized
Configuration before Maintenance Action
29-13-00-710-002 Operational Test of the Yellow Hydraulic System
29-14-00-614-001 Depressurization of the Hydraulic Reservoirs
R 71-13-00-410-040 Closing of the Fan Cowl Doors 29-13-49-991-904 Fig. 401 29-13-49-991-905 Fig. 402
3. Job Set-up
__________
Subtask 29-13-49-860-060
A. Aircraft Maintenance Configuration
(1)
Make sure that the Yellow hydraulic system is depressurized and put it in the maintenance configuration. (Ref. TASK 29-00-00-864-001)
(2)
Make sure that the Yellow hydraulic reservoir is depressurized (Ref. TASK 29-14-00-614-001).
(3)
Make sure that the warning notice(s) is (are) in position to tell persons not to pressurize the Yellow hydraulic system: - on the ground service panel 198CB.
(4)
Make sure that the warning notice(s) is (are) in position on the access door 195BB to tell persons not to pressurize the Yellow hydraulic reservoir.
(5)
Make sure that the access platform is in position at the engine 1(2).
(6)
Make sure that the fan-cowl door 447AL is open.
Subtask 29-13-49-941-064
B. Safety Precautions
(1)
On the center pedestal, on the ENG panel 115VU:
-make sure that warning notice(s) is (are) in position to tell persons not to start the engine.
(2)
Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3)
Make sure that the warning notice(s) is (are) in position to tell persons not to pressurize the Yellow hydraulic system:
-in the cockpit, on the HYD section of the overhead panel 40VU.
(4)
On the overhead maintenance panel 50VU:
-make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(5)
Make sure that the warning notice(s) is (are) in position to tell persons not to energize the FADEC 1(2).
(6)
Make sure that a container is below the suction-hose adapter connection to the hydraulic pump.
Subtask 29-13-49-865-052
C. Make sure that this(these) circuit breaker(s) is(are) open, safetied and tagged
-------------------------------------------------------------------------------PANEL DESIGNATION IDENT. LOCATION -------------------------------------------------------------------------------
121VU HYDRAULIC/Y HYD/PUMP ENG2/MONG 3700GD Q37
4. Procedure
_________
(Ref. Fig. 401/TASK 29-13-49-991-904, 402/TASK 29-13-49-991-905) Subtask 29-13-49-420-054
A. Installation of the Hydraulic Suction Hose/Tube Assembly
(1)
Remove the protective covers from the ends of the suction hose/tube (25), the fluid disconnect panel and the union in the hydraulic pump.
(2)
Connect the coupling half (15) to the suction hose/tube (25).
(3)
TORQUE the coupling nut on the suction hose/tube (25) to between 9.04
and 10.2 m.daN (66.66 and 75.22 lbf.ft).
(4)
Connect the adapter assembly (60) to the suction hose/tube (25).
(5)
TORQUE the coupling nut on the suction hose/tube (25) to between 10.7 and 13.0 m.daN (78.90 and 95.87 lbf.ft).
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：A320飛機維護手冊 AMM HYDRAULIC POWER 液壓4(67)
