曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

their responsibilities to the fullest.
e. The responsibilities of the pilot and the
controller intentionally overlap in many areas
providing a degree of redundancy. Should one or the
other fail in any manner, this overlapping responsibility
is expected to compensate, in many cases, for
failures that may affect safety.
f. The following, while not intended to be all
inclusive, is a brief listing of pilot and controller
responsibilities for some commonly used procedures
or phases of flight. More detailed explanations are
contained in other portions of this publication, the
appropriate CFRs, ACs and similar publications. The
information provided is an overview of the principles
involved and is not meant as an interpretation of the
rules nor is it intended to extend or diminish
responsibilities.
5-5-2. Air Traffic Clearance
a. Pilot.
1. Acknowledges receipt and understanding of
an ATC clearance.
2. Reads back any hold short of runway
instructions issued by ATC.
3. Requests clarification or amendment, as
appropriate, any time a clearance is not fully
understood or considered unacceptable from a safety
standpoint.
4. Promptly complies with an air traffic
clearance upon receipt except as necessary to cope
with an emergency. Advises ATC as soon as possible
and obtains an amended clearance, if deviation is
necessary.
NOTEA
clearance to land means that appropriate separation on
the landing runway will be ensured. A landing clearance
does not relieve the pilot from compliance with any
previously issued altitude crossing restriction.
b. Controller.
1. Issues appropriate clearances for the operation
to be conducted, or being conducted, in
accordance with established criteria.
2. Assigns altitudes in IFR clearances that are at
or above the minimum IFR altitudes in controlled
airspace.
3. Ensures acknowledgement by the pilot for
issued information, clearances, or instructions.
4. Ensures that readbacks by the pilot of
altitude, heading, or other items are correct. If
incorrect, distorted, or incomplete, makes corrections
as appropriate.
AIM 2/14/08
5-5-2 Pilot/Controller Roles and Responsibilities
5-5-3. Contact Approach
a. Pilot.
1. Must request a contact approach and makes it
in lieu of a standard or special instrument approach.
2. By requesting the contact approach, indicates
that the flight is operating clear of clouds, has at least
one mile flight visibility, and reasonably expects to
continue to the destination airport in those conditions.
3. Assumes responsibility for obstruction clearance
while conducting a contact approach.
4. Advises ATC immediately if unable to
continue the contact approach or if encounters less
than 1 mile flight visibility.
5. Is aware that if radar service is being received,
it may be automatically terminated when told to
contact the tower.
REFERENCEPilot/
Controller Glossary Term- Radar Service Terminated.
b. Controller.
1. Issues clearance for a contact approach only
when requested by the pilot. Does not solicit the use
of this procedure.
2. Before issuing the clearance, ascertains that
reported ground visibility at destination airport is at
least 1 mile.
3. Provides approved separation between the
aircraft cleared for a contact approach and other IFR
or special VFR aircraft. When using vertical
separation, does not assign a fixed altitude, but clears
the aircraft at or below an altitude which is at least
1,000 feet below any IFR traffic but not below
Minimum Safe Altitudes prescribed in 14 CFR
Section 91.119.
4. Issues alternative instructions if, in their
judgment, weather conditions may make completion
of the approach impracticable.
5-5-4. Instrument Approach
a. Pilot.
1. Be aware that the controller issues clearance
for approach based only on known traffic.
2. Follows the procedure as shown on the IAP,
including all restrictive notations, such as:
(a) Procedure not authorized at night;
(b) Approach not authorized when local area
altimeter not available;
(c) Procedure not authorized when control
tower not in operation;
(d) Procedure not authorized when glide
slope not used;
(e) Straight‐in minimums not authorized at
night; etc.
(f) Radar required; or
(g) The circling minimums published on the
instrument approach chart provide adequate obstruction
clearance and pilots should not descend below
the circling altitude until the aircraft is in a position
to make final descent for landing. Sound judgment
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：航空信息手冊2008下(36)