国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽

  • 熱門標簽

當前位置: 主頁 > 航空資料 > 國外資料 >

時間:2010-05-28 01:19來源:藍天飛行翻譯 作者:admin
曝光臺 注意防騙 網(wǎng)曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

c. Straight-in Minimums are shown on the IAP
when the final approach course is within 30 degrees
of the runway alignment (15 degrees for GPS IAPs)
and a normal descent can be made from the IFR
altitude shown on the IAP to the runway surface.
When either the normal rate of descent or the runway
alignment factor of 30 degrees (15 degrees for GPS
IAPs) is exceeded, a straight-in minimum is not
published and a circling minimum applies. The fact
that a straight-in minimum is not published does not
preclude pilots from landing straight-in if they have
the active runway in sight and have sufficient time to
make a normal approach for landing. Under such
conditions and when ATC has cleared them for
landing on that runway, pilots are not expected to
circle even though only circling minimums are
published. If they desire to circle, they should advise
ATC.
d. Side-Step Maneuver Minimums. Landing
minimums for a side-step maneuver to the adjacent
runway will normally be higher than the minimums
to the primary runway.
e. Published Approach Minimums. Approach
minimums are published for different aircraft
categories and consist of a minimum altitude (DA,
DH, MDA) and required visibility. These minimums
are determined by applying the appropriate TERPS
criteria. When a fix is incorporated in a nonprecision
final segment, two sets of minimums may be
published: one for the pilot that is able to identify the
fix, and a second for the pilot that cannot. Two sets of
minimums may also be published when a second
altimeter source is used in the procedure. When a
nonprecision procedure incorporates both a
stepdown fix in the final segment and a second
altimeter source, two sets of minimums are published
to account for the stepdown fix and a note addresses
minimums for the second altimeter source.
f. Circling Minimums. In some busy terminal
areas, ATC may not allow circling and circling
minimums will not be published. Published circling
minimums provide obstacle clearance when pilots
remain within the appropriate area of protection.
Pilots should remain at or above the circling altitude
until the aircraft is continuously in a position from
which a descent to a landing on the intended runway
can be made at a normal rate of descent using normal
maneuvers. Circling may require maneuvers at low
altitude, at low airspeed, and in marginal weather
conditions. Pilots must use sound judgment, have an
indepth knowledge of their capabilities, and fully
understand the aircraft performance to determine the
exact circling maneuver since weather, unique airport
design, and the aircraft position, altitude, and
airspeed must all be considered. The following basic
rules apply:
1. Maneuver the shortest path to the base or
downwind leg, as appropriate, considering existing
weather conditions. There is no restriction from
passing over the airport or other runways.
2. It should be recognized that circling
maneuvers may be made while VFR or other flying
is in progress at the airport. Standard left turns or
specific instruction from the controller for
maneuvering must be considered when circling to
land.
3. At airports without a control tower, it may be
desirable to fly over the airport to observe wind and
turn indicators and other traffic which may be on the
runway or flying in the vicinity of the airport.
g. Instrument Approach at a Military Field.
When instrument approaches are conducted by civil
aircraft at military airports, they shall be conducted in
accordance with the procedures and minimums
approved by the military agency having jurisdiction
over the airport.
5−4−21. Missed Approach
a. When a landing cannot be accomplished, advise
ATC and, upon reaching the missed approach point
defined on the approach procedure chart, the pilot
must comply with the missed approach instructions
for the procedure being used or with an alternate
missed approach procedure specified by ATC.
b. Obstacle protection for missed approach is
predicated on the missed approach being initiated at
the decision altitude/height (DA/H) or at the missed
approach point and not lower than minimum descent
altitude (MDA). A climb gradient of at least 200 feet
per nautical mile is required, (except for Copter
approaches, where a climb of at least 400 feet per
nautical mile is required), unless a higher climb
gradient is published in the notes section of the
approach procedure chart. When higher than standard
climb gradients are specified, the end point of the
 
中國航空網(wǎng) m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址:航空信息手冊2008下(31)
国产男女无遮挡_日本在线播放一区_国产精品黄页免费高清在线观看_国产精品爽爽爽
国产厕所精品在线观看| 久久国产精品视频在线观看| 国产亚洲二区| 久久国产精品视频在线观看| 国产精品久久视频| 亚洲v日韩v综合v精品v| 欧美最猛性xxxx| 99电影在线观看| 国产精品国产精品| 日韩欧美视频网站| 91精品免费看| 欧美精品一二区| 欧美精品久久久久久久免费| 国产精品91久久久| 国产精品久久久亚洲| 一区二区免费在线观看| 黄色一级在线视频| 久久99精品久久久久久久久久| 国产精品-区区久久久狼| 午夜欧美不卡精品aaaaa| 国产色综合天天综合网| 69久久夜色精品国产69乱青草| 欧美人与性动交| 精品一区在线播放| 久久国产精品高清| 午夜精品久久久久久99热软件| 高清一区二区三区日本久 | 成人免费91在线看| 中文字幕中文字幕在线中一区高清 | 国产主播在线一区| 美日韩精品免费观看视频| 国产乱人伦真实精品视频| 中文字幕99| 91av免费看| 日韩久久久久久久| 国产精品久久久久久久电影| 国产日韩欧美夫妻视频在线观看| 在线观看一区欧美| 91成人免费观看网站| 热久久精品免费视频| 国产精品久久久久77777| 成人伊人精品色xxxx视频| 欧美一区二区三区综合| 国产成人精品视频在线观看| 国产日韩三区| 性欧美亚洲xxxx乳在线观看| 久久精品国产精品亚洲| 国产日韩欧美视频在线| 午夜免费福利小电影| 久久久久久久激情| 国产亚洲精品网站| 午夜美女久久久久爽久久| 日韩中文字幕视频在线观看| 欧美成人综合一区| 在线视频精品一区| 久久久久久人妻一区二区三区| 国产在线拍偷自揄拍精品| 亚洲人成人77777线观看| 日韩在线观看你懂的| 国产日韩欧美视频| 日韩aⅴ视频一区二区三区| 国产精品久久久久9999| 91九色对白| 韩国v欧美v日本v亚洲| 亚洲一区二区三区sesese| 久久久精品国产| www亚洲国产| 欧美 日韩 国产在线| 中文视频一区视频二区视频三区| 久久久久久久999精品视频| 国产乱人伦真实精品视频| 日韩精品综合在线| 亚洲综合五月天| 国产精品无码电影在线观看| 成人精品视频在线播放| 欧美区高清在线| 在线视频不卡一区二区三区| 日韩在线精品视频| 成人3d动漫一区二区三区| 欧美日韩一区在线观看视频| 婷婷五月色综合| 最新不卡av| 国产精品国产三级国产aⅴ9色| 99视频日韩| 国产日韩精品在线观看| 欧美中文在线免费| 欧美一级视频在线观看| 久国内精品在线| 国产成人精品一区二区在线| 91免费视频网站在线观看| 美日韩精品免费| 秋霞在线观看一区二区三区| 亚洲中文字幕无码一区二区三区 | 精品国产美女在线| 国产精品69久久久| 精品无人区一区二区三区竹菊| 日韩影院一区| 一道精品一区二区三区| 精品国产区在线| 国产精品久久久久久久久久99| 久久国产精品精品国产色婷婷| 99中文视频在线| 国产伦精品一区二区三区免| 国产又粗又猛又爽又黄的网站| 日韩女优在线播放| 日本在线视频不卡| 川上优av一区二区线观看| 一本色道久久综合亚洲精品婷婷| 欧美精品一区三区| 国产精品成人va在线观看| www.日韩不卡电影av| 九色自拍视频在线观看| 久久免费成人精品视频| 国产极品尤物在线| 91精品视频免费| 97国产精品久久| 91精品国产九九九久久久亚洲| 国产精品午夜国产小视频| 国产卡一卡二在线| 国产美女精品久久久| 国产精品一区二区在线| 国产精品一区在线播放| 国产精选久久久久久| 粉嫩av四季av绯色av第一区| www.亚洲天堂网| 91精品国产高清自在线| 69精品小视频| 国产xxx69麻豆国语对白| 国产高清在线精品一区二区三区| 国产传媒欧美日韩| 日韩在线观看免费av| 久久色免费在线视频| 久久久久www| 欧美成人免费一级人片100| 欧美激情在线观看视频| 在线视频不卡国产| 五月天综合婷婷| 热久久99这里有精品| 欧美日韩亚洲国产成人| 国产中文一区二区| 国产日韩欧美电影在线观看| 国产综合久久久久| 分分操这里只有精品| 91精品免费| 国产不卡av在线| 国产精品普通话| 欧美激情综合亚洲一二区| 亚洲精品国产精品国自产| 日本阿v视频在线观看| 欧美二区在线看| 成人精品网站在线观看| 国产成人精品日本亚洲| 国产精品网址在线| 在线日韩av永久免费观看| 日本一区不卡| 精品一区二区成人免费视频| 国产欧美日韩亚洲精品| 久久综合九九| 久久天天躁狠狠躁夜夜av| 欧美日韩高清区| 日韩欧美电影一区二区| 国产亚洲精品网站| 国产福利一区视频| 久久综合免费视频| 日韩在线xxx| 精品一区久久| 久久免费国产精品1| 国产精品第8页| 午夜精品99久久免费| 欧美激情 国产精品| av免费观看网| 日韩中文字幕网站| 一区二区三区三区在线| 日本在线播放一区| 国产一区二区黄色| 久久精品成人一区二区三区蜜臀 | 欧美精品xxx| 日本在线成人一区二区| 国产麻花豆剧传媒精品mv在线| 久久久噜噜噜久久| 精品久久中出| 欧美有码在线视频| 北条麻妃在线一区| 日韩中文字幕亚洲| 亚洲午夜精品一区二区| 国内偷自视频区视频综合| 国产极品jizzhd欧美| 欧美激情欧美激情在线五月| 欧美少妇在线观看| 国产成人在线免费看| 欧美日韩高清区| 欧美这里只有精品| 91精品视频专区| 久久中文字幕在线视频| 欧美中日韩免费视频| 99精品在线直播| 精品丰满人妻无套内射| 欧美视频1区| 99精品99久久久久久宅男| 国产精品久久久久7777婷婷|