2

Attach 4 screws in hinge bracket to attach literature pocket structural assembly.
(g)  Install Maintenance Cover / Kinematic Cover . Last Row (Ref Fig 3001 sheet 1/7) 1
Align maintenance cover/ kinematic cover onto literature pocket structural assembly. 2
Attach 4 screws and 4 washers.
3 Press hook and loop tape to engage.

(h)  
Install Maintenance Cover / Kinematic Cover . Typical (Ref Fig 3001 sheet 1/7) 1 Align maintenance cover / kinematic cover onto literature pocket structural assembly. 2 Attach 4 screws and 4 washers accessing holes from under the literature structural

assembly.
3 Press hook and loop tape to engage.

(i)  
Install Latch (Arm Assembly) (Ref Fig 3001 sheet 5) 1 Align lower latch housing and cable assembly beside forward end of armrest panel

assembly. 2 Slide forward armrest beam over cable assembly and onto armrest panel assembly. 3 Attach forward armrest beam onto armrest panel assembly with 4 screws and 4 washers
in 4 lower holes. 4 Attach lower latch housing to armrest panel assembly with 2 screws and 2 nuts. 5 Swivel top of cable assembly forward. 6 Slide adapter bracket down over armrest beam and cable assembly. 7 Swivel top of cable assembly aft. 8 Install 2 screws and 2 washers to attach adapter bracket to forward armrest beam. 9 Install 1 screw into the cable assembly/adapter bracket. 10 Slide upper latch housing aft capturing cable assembly. 11 Install 2 screws to attach the upper latch housing. 12 Install latch lever.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
654 SERIES

13  Verify that the double.back tape on the forward deco extrusions are in good conditions. Replace if necessary.
14  Install 2 forward deco extrusions.

(j)  
Install Latch Lever (Arm Assembly) (Ref Fig 3001 sheet 5)

1  Slide latch lever aft and use a twisting motion to engage latch lever in upper latch housing.

(k)  
Install Armrest Foam Assembly (Ref Fig 3001 sheet 5/6) 1 Slide armrest foam assembly onto arm assembly. 2 Place aft end cap onto arm assembly. 3 Install 2 screws to attach aft end cap. 4 Verify that the double.back tape on the aft beam cover is in good condition. Replace if

necessary.
5 Install 1 aft beam cover.

(l)  
Install Arm Assembly (Ref Fig 3001 sheet 5/6) 1 Gently slide arm assembly into hole in end bay arm rest trim. 2 Attach 1 bolt to attach arm assembly to end bay assembly. 3 Align gas spring plunger side down. 4 Attach gas spring with 2 retaining rings. 5 Verify latch engages and disengages.

(m)  
.Install Literature Door Latch (Ref Fig 3001 sheet 4) 1 Position center latch component into hole in literature door. 2 Attach latch support bracket with two screws. 3
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(42)