曝光臺 注意防騙 網曝天貓店富美金盛家居專營店坑蒙拐騙欺詐消費者

C.  The seats can be returned to their take.off, taxi, and landing position (TTL) by pulling the buttons A, C. Pull the strap underneath the legrest, holding the push button (C). For the checking of reached final TTL.position, there are two buttons at seat endbay aisle side. For lateral seat units the upper button controls outboard seat.place, the lower button controls aisle seat.place. When one of these buttons shows a red band, then the respective seat.place is not set to the correct TTL position.
D  EPS Configuration
(Ref figure 1002)

At first into service the EPS Software for all seats is configurated as DBL seat. Therefore the TPL seats shall be reconfigurated with following instructions:
(1)  Enter the Service Menu by pressing [<] + [>] for more than 3sec (only within 15sec after ”888” on display at power on). EPS BITE displays code 101 if Maintenance Mode is successfully entered.

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
(2)  
When in menu 101 service menu 102 can be selected with [<] or [>]. To enter seat configuration menu [M] will revert into seat selection 1, 2, 3, 1,...

(3)  
Depress [<] or [>] to scroll through pax setting. Choose the requested pax number

(4)  
Depress [M] again longer than 2 seconds. EPS Bite displays code 102.

(5)  
Depress [M] again longer than 2 seconds. New pax number is stored. Expect display 100 for 1 second to indicate successful completion.

NOTE: EPS BITE display will resume normal display mode (pitch, 001, failures if present). Once the Maintenance Mode is entered and not completed within 2 minutes the pax value will not change.

T CONTROL PANEL, USED BUTTONS FOR CONFIGURATION
FIGURE 1002

 

Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
654 SERIES

TROUBLE CODE #  PROBABLE CAUSE  DETAILS  CORRECTIVE ACTION 
STATUS MESSAGES 
200  EPS disabled  An error caused the deactivation of EPS  See other Failurecodes for reason 
201  LH Movement disabled  An error caused the deactivation of movement  See other Failurecodes for reason 
202  RH Movement disabled  An error caused the deactivation of movement  See other Failurecodes for reason 
203  LH2 Movement disabled  An error caused the deactivation of movement  See other Failurecodes for reason 
213  EPS in SLEEP Mode  Only indication  Only indication 
214  EPS in Power Limitation Mode  Only indication  Only indication 
KEYS 
300  LH Pressed Key Backrest up  This Key is pressed  If codes not match to the pressed keys, check IPCU 
　
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757&#8722;200 PASSENGER SEAT 乘客座椅(12)