(2)
Procedure (For Illustration Ref Dissasembly)
CAUTION: WHILE PERFOMING MAINTENANCE PROCEDURES, USE CARE TO AVOID DAMAGE TO DECORATIVE SURFACES WITH TOOLS, MATERIALS AND EQUIPMENT. PERFORM ALL WORK ON A CLEAN PADDED WORK SURFACE. KEEP DECORATIVE SURFACES COVERED WITH AN APPROPRIATE PROTECTIVE COVER.
(a) Install Deco Panels (Ref Fig 3001 sheet 1)
Install is typical for the following deco panels: Standard Literature Closeout Assembly; Standard Aft Back Shell; S.Shaped Panel; Forward with Eagle; Deco Literature Closeout Panel.
1 Verify that the double.back tape or hook and loop tape is in good condition. Replace if necessary.
2 Align deco panel and press into place.
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
654 SERIES
(b) Install Deco Panels (Ref Fig 3001 sheet 1)
Install is typical for the following deco panels: Inboard End Bay Assembly; Outboard End Bay Assembly, 1
Verify that the double.back tape or hook and loop tape is in good condition. Replace if necessary.
2 Slide deco panel under arm rest cap trim.
3 Connect electrical wiring to proximity lights, if necessary.
4 Align deco panel and press into place.
5 Gently slip forward end of deco panel under end by cap trim.
(c)
Install Proximity Light (Ref Fig 3001 sheet 6) 1 Open circuit breakers for seat shells. 2 Slip proximity light through end bay outboard panel. 3 Snap backing plate onto proximity light on the opposite side of the end bay outboard
panel.
4 Connect electrical connector.
(d)
Install End Cap Trim Assembly (Ref Fig 3001 sheet 2) 1 Install 6 screws (5 screws on outboard seats) to install end cap trim assembly. 2 Verify that the double.back tape on the back of the forward deco extrusions are in good
condition. Replace if necessary. 3 Align 2 forward deco extrusions onto forward armrest beam and press into place.
(e) Install Rear Bumper Assembly (Ref Fig 3001 sheet 2) 1 Align rear bumper assembly onto shell assembly. 2 Engage inboard flange to literature pocket structural assembly. 3 Install 2 screws on outboard rear bumper assembly to secure to shell assembly.
(f) Install Literature Pocket Structural Assembly (Ref Fig 3001 sheet 1) 1
Align literature pocket structural assembly in shell assembly.
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(41)
