(d)
REMOVE MONITOR SHROUD (Ref Fig 3001 sheet 2)
For removal the Monitor see TBD instructions. The following instructions are assuming that the
monitor is not installed.
1 Remove Deco Panel Forward with Eeagle. (Ref Step (b))
2 From aft side of seat, tilt top of monitor shroud aft and hold.
3 Remove 2 screws from side of monitor shroud.
4 Unhook montor shroud from video shroud frame assembly.
(e)
REMOVE TABLE LATCH (Ref Fig 3001 sheet 2) 1 Remove Deco Panel Forward with Eagle. (Ref Step (b)) 2
If possible, lower table.
3
Remove 2 screws to remove table latch.
(f) REMOVE COAT HOOK (Ref Fig 3001 sheet 2) 1
Pull coat hook lever aft.
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE 654 SERIES
2 Remove 2 screws lcoated behind the lever to remove cat hook.
(g) REMOVE TABLE INLAY ASSEMBLY (Ref Fig 3001 sheet 3) 1
Unhook table latch and lower table.
2
Gently peel up table inlay to disengage from double stick tape
(h)
REMOVE TABLE T.BAR (Ref Fig 3001 sheet 3) 1 Unhook table latch and lower table. 2 Remove 2 screws to remove cover. 3 Remove 2 screws per T.bar.
(i)
REMOVE LITERATURE POCKET TRIM ASSEMBLY (Ref Fig 3001 sheet 2) 1 Open Literature Pocket Doore. 2 Remove 5 screws and 5 wshers to remove literature pocet trim assembly.
(j)
REMOVE LITERATURE DOOR (Ref Fig 3001 sheet 2/4) 1 Open Literature Door. 2 Disengage deco literature closeout panel to access fasteners, if necessary. 3 Remove 4 screws from hinge to remove literature pocket door.
(k)
REMOVE LITERATUR DOOR lATCH (Ref Fig 3001 sheet 4) 1 Open Literature Door. 2 Remove 4 screws to remove cover. 3 Remove 2 screws to remove latch support bracket. 4 Remove 4 screws to unfasten 2 outer latch components and latch mount blocks. 5 Slide outer latch components away from rods. 6
(l)
REMOVE ARM ASSEMBLY (Ref Fig 3001 sheet 5; 6)
Slide rods away from center latch components.
7
Rotate and slide center latch component out of the door panel.
Recaro Aircraft Seating GmbH & Co. KG, Daimlerstrasse 21, D.74523 Schw.bisch Hall
COMPONENT MAINTENANCE MANUAL . 6510A TYPE
654 SERIES
1 Remove outboard end bay deco panel. (Ref Step (c))
2 Remove 2 retaining rings to remove gas spring.
3 Remove 1 bolt from aft section of arm assembly
4 Pull up on latch lever to realese latch.
5 Pull arm assembly up through hole in end bay arm rest trim.
中國航空網 m.k6050.com
航空翻譯 www.aviation.cn
本文鏈接地址：COMPONENT MAINTENANCE MANUAL WITH ILLUSTRATED PARTS LIST B757−200 PASSENGER SEAT 乘客座椅(32)
